ASP-100-2-SS Industry Standard Clamping Collar, 2-Piece Construction, 1 in ID x 1-3/4 in OD x 1/2 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
-
BrandClimax
-
UPC044861630730
-
Manufacturer Part NumberG2SC-100-SS
-
CountryUSA
-
FinishPlain
-
MaterialStainless Steel
-
TypeIndustry Standard
-
Construction2-Piece
-
Screw Size1/4-28 UN-3A x 5/8 in
-
Width1/2 in
-
SeriesG2SC
-
Inside Diameter1 in
-
Outside Diameter1-3/4 in
- Easily installed where major disassembly would otherwise be required
- Greater axial holding power than setscrew or 1-piece clamping collars
- Effective on hard and soft shafts
- Without recessed screw
- Design fully engages the shaft without marring
-
UNSPSC31162811
-
Package DescriptionEACH
-
Standards/ApprovalsASTM A582|ASTM F837 Cap Screw
-
Specification Sheet
-
Line Drawing
Recently Viewed
ASP-100-2-SS Industry Standard Clamping Collar, 2-Piece Construction, 1 in ID x 1-3/4 in OD x 1/2 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
Kuri Tec® SJMD200x100 SJMD Contractor Grade Mill Single Jacket Discharge Hose, Hose End Style, 100 ft L, 150 psi Working, Rubber/Polyester, Import
Kuri Tec® SJMD200x100 SJMD Contractor Grade Mill Single Jacket Discharge Hose, Hose End Style, 100 ft L, 150 psi Working, Rubber/Polyester, Import
Morse® 131803 MHSTK Hole Saw, 5 in Dia, 1-15/16 in D Cutting, Carbide Cutting Edge, 5/8 to 18 Arbor
3/8" DIAMETERX1-1/2" DOWEL PIN-HOL01098 >
Morse® AV62 Master Cobalt® Heavy Duty Hole Saw, 3-7/8 in Dia, 1-1/2 in D Cutting, M3 HSS Cutting Edge
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
