Makita 120-VOLT 11-3/4" CHAINSAWS MAK 5012-B
11-3/4" ELECTRIC CHAINSAW - MAK5012B >
Recently Viewed
11-3/4" ELECTRIC CHAINSAW - MAK5012B >
HCI Preferred Supplier 20260 Tube Connector, 1/4 in, Poly-Flo® Flareless x Female NPTF, CA360 Brass
HCI Preferred Supplier 20260 Tube Connector, 1/4 in, Poly-Flo® Flareless x Female NPTF, CA360 Brass
This Wagner® WG840586 Direct Drive Furnace Blower Motors, 1/3hp, 1075/3 RPM, 2.2FLA, 208-230V motor installs with all standard 48 frame mounting brackets. It is protected by an automatic overload and class B insulation. The motor is electrically reversible and features 36 in. leads to ease installation.
THRUST BEARING-INA902>
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
Browning® 1296482 T55L Automatic Torque Limiter, 1 in Finished Bore, 5-1/2 in OD, 3800 in-lb (1-Spring)/6800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
