902 INA BEARING COMPANY
THRUST BEARING-INA902>
Recently Viewed
THRUST BEARING-INA902>
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
Browning® 1296482 T55L Automatic Torque Limiter, 1 in Finished Bore, 5-1/2 in OD, 3800 in-lb (1-Spring)/6800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
1-1/4" X 4" M/D RECT DIE SPRINGS-LANSMDR1250400 >
Milton s976 Dual Head Tire Pressure Gauge, 10-160 PSI, Dually Tire Pressure Gauge, Truck, Tractor Trailer, RV & Car
Dual chuck head Service Gauge has a maximum pressure of 160 psi. Milton® precision engineered Service Gauges provide accurate, long life and trouble-free performance. Plated brass tube and 4 sided nylon indicator bar. 100% Calibrated across all three psi ranges before leaving the factory.
Wilton Classic 400 series c-clamps are ideal for steel fabrication, industrial maintenance and repair operations. Each c-clamp is drop forged and features an ACME rolled spindle with black oxide coating, replaceable Perma-Pads® and a V-grooved anvil for secure holding of all materials.
