Enerpac® RR-1012 Double Acting Long Stroke Hydraulic Cylinder, 10 ton Capacity, 12 in L Stroke, 10000 psi
Enerpac® hydraulic cylinders are available in hundreds of different configurations. Whatever the industrial application lifting, pushing, pulling, bending, holding, whatever the force capacity, stroke length, or size restrictions, single- or double-acting, solid or hollow plunger, you can be sure that Enerpac® has the cylinder to suit your high force application.
-
BrandEnerpac®
-
UPC662005303311
-
Manufacturer Part NumberRR-1012
-
CountryUSA
-
Capacity10 ton
-
FinishBaked Enamel
-
Pressure Rating10000 psi
-
TypeDouble Acting Long Stroke
-
SeriesRR
-
Housing MaterialSteel
-
Stroke Length12 in
- Double acting cylinders are rugged enough for the toughest job site uses and precision designed for high cycle industrial use
- Collar threads, plunger threads and base mounting holes enable easy fixturing (on most models)
- Baked enamel finish for increased corrosion resistance
- Removable hardened saddles protect plunger during lifting and pressing
- Built-in safety valve prevents accidental over pressurization
- Plunger wiper reduces contamination, extending cylinder life
- 2.23 sq-in push/0.8 sq-in pull cylinder effective area
- 18 in collapsed height
- 30 in extended height
- 1.69 in cylindrical bore diameter
- 1.44 in base to advance port
- 2-1/4 in top to return port
- 1.38 in saddle diameter
- 0.24 in saddle protrusion from plunger
- 1-8 plunger internal thread
- 1 in plunger thread length
- 2-1/4 -14 in collar thread
- 1.06 in collar thread length
- 2.88 in outside diameter
-
UNSPSC27121602
-
Standards/ApprovalsASME B30.1
-
Instruction/Installation Manual
-
Catalog
-
Specification Sheet
Recently Viewed
Enerpac® RR-1012 Double Acting Long Stroke Hydraulic Cylinder, 10 ton Capacity, 12 in L Stroke, 10000 psi
Enerpac® hydraulic cylinders are available in hundreds of different configurations. Whatever the industrial application lifting, pushing, pulling, bending, holding, whatever the force capacity, stroke length, or size restrictions, single- or double-acting, solid or hollow plunger, you can be sure that Enerpac® has the cylinder to suit your high force application.
Leviton® 13353-N Standard Lampholder, 660 W Lamp, 600 VAC, Medium Bi-Pin Fluorescent Lamp
MINI-PULLER, 1/2" TON 0R 1,100LB LOAD CAPACITY, VERY COMPACT & LIGHTWEIGHT, LOW PULLING FORCE REQUIRED FOR OPERATION, 5FT LIFT-HRHLX0055 >
1-15/16" -ID 2-B PILLOW BLOCK UNIT-BRWSPB1100EX115/16 >
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. A matching high shoulder is often on the opposite side of the inner ring as well. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. This ball bearing has a 40 deg contact angle. This bearing has a stamped steel cage and is not available with seals or shields. These bearings are non-separable. These bearings have normal tolerances and are not suitable for mounting adjacent to each other to achieve a preload.
1-7/16" -ID PILLOW BLOCK UNIT-BRWPB950EX17/16 >
