Alemite® 6320-3 High Pressure Control Valve, 7500 psi Pressure Rating, 1/4 in NPTF x 1/8 in NPTF Thread Connection, Grease Media, Steel
Alemite® 6320-3 High Pressure Control Valve, 7500 psi Pressure Rating, 1/4 in NPTF x 1/8 in NPTF Thread Connection, Grease Media, Steel
-
BrandAlemite®
-
UPC098468105825
-
Manufacturer Part Number6320-3
-
CountryCanada
-
MaterialSteel
-
TypeHigh Pressure
-
Series6320
-
Specifications7500 psi Pressure Rating, 1/4 in NPTF x 1/8 in NPTF Thread Connection, Grease Media
- High pressure control valve provides continuous flow with the trigger fully depressed and delivers measured, preset amounts with the trigger partially depressed
- Provides high pressure lubrication
- System may be piped to any part of the plant from one centrally-located lubricant area
- Eliminates need for lubricant substations and duplicated equipment
- Control valve supplies a single measured shot or a continuous flow of lubricant
- System consists of air operated lubricant pump, lubricant pipe line, snap on coupler stations and tote-A-hose control valve assembly
- Does not engage fitting directly, selector provides full flow, wide range of measured shots
- Built-in three-stage strainer prevents dirt from fouling valve or damaging bearings
- Accurately controls amount of lubricant dispensed
- Normally used on production lines to lubricate small bearings
- Adjustment screw regulates amount of lubricant
- Handles fibrous, light and heavy greases, semi-fluid and fluid lubricants
- Pistol grip handle
| Competitor Name | Cross-Reference Number |
|---|---|
| Applied Industrial Technologies | 100874159 |
-
UNSPSC40141608
Recently Viewed
Alemite® 6320-3 High Pressure Control Valve, 7500 psi Pressure Rating, 1/4 in NPTF x 1/8 in NPTF Thread Connection, Grease Media, Steel
Alemite® 6320-3 High Pressure Control Valve, 7500 psi Pressure Rating, 1/4 in NPTF x 1/8 in NPTF Thread Connection, Grease Media, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
METRIC V-BELT 1632MM-JASSPA1632 >
SERPENT SAFETY HELMET-HI VIZ ORANGE, ULTRA COMFORTABLE, VENTED HARD HAT THAT KEEPS WORKERS COOLER, SNAKE HEAD SHELL DESIGN, MANUFACTURED FROM A HIGH-DENSITY POLYETHYLENE THAT?-GSI71216 >
Diablo® DS0910CF3 Reciprocating Saw Blade, 9 in L, 10 TPI
