Starrett CENTER PUNCHES STR 117-C
The Starrett 117 Center Punch is made of specially selected steel, hardened and properly tempered. It is well proportioned, nicely finished and has a knurled finger grip. The points are ground at the proper angle to give maximum service, and the tips are accurately centered. 4" (100mm) Length, 1/8" (3mm) Point Diameter.
-
BrandStarrett®
-
UPC049659504859
-
Manufacturer Part Number117C
-
CountryUSA|Canada
-
Tip MaterialSteel
-
Tip Size1/8 in
-
Handle TypeKnurled/Round
-
Overall Length4 in
- Precision Centered Tips for Accuracy
- Knurled Grip for secure holding
- The points are ground at the proper angle to give maximum service
- Hardened and Tempered
- Made of specially selected steel
| Competitor Name | Cross-Reference Number |
|---|---|
| MSC | 86404977 |
| Grainger | 26Y852 |
| Fastenal | 0324848 |
-
UNSPSC27111500
-
Package DescriptionEACH
-
Full Engineering Drawing
Recently Viewed
The Starrett 117 Center Punch is made of specially selected steel, hardened and properly tempered. It is well proportioned, nicely finished and has a knurled finger grip. The points are ground at the proper angle to give maximum service, and the tips are accurately centered. 4" (100mm) Length, 1/8" (3mm) Point Diameter.
Type S flanges sizes 6 through 16 are manufactured of high strength cast iron then bored-to-size for slip fit on standard shafts. Size 5 is made of sintered carbon steel. Flanges are easy to install and remove, and are stocked in a wide range of bore sizes. All sleeve materials may be used with type S flanges.
Sealmaster 3-7/16"-ID 4-BOLT BB PILLOW BLOCKS SEA MSFPD-55
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
BBI 360130 Fender Flat Washer, 3/16 in ID x 1-1/4 in OD, Low Carbon Steel
SK-1 QUICK DISCONNECT BUSHING WITH A 1" BORE, 1/4' X 1/8' KEYWAY-BRWSK1 >
Browning® 767512 VTWS Medium Duty Take-Up Ball Bearing Unit With Seal Flinger, 2-3/16 in Dia Bore, 7-1/4 in L x 2-1/2 in W x 5-3/4 in H, 11789 lb Dynamic/8150 lb Static Load
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric or BOA concentric locking collar. The contact seal with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction.
