PBTO-3/0 ILSCO Wire Splicers
Conductor Range: 3/0 AWG to 6 AWG Voltage Rating: 600 Volts Amperage Rating: 225 Amps Number of Ports: 2 ports (in-line offset configuration) Temperature Range: -45°C to 90°C [-45°F to 194°F]Material: Tin-plated aluminum body with high dielectric strength plastisol insulation
Recently Viewed
Conductor Range: 3/0 AWG to 6 AWG Voltage Rating: 600 Volts Amperage Rating: 225 Amps Number of Ports: 2 ports (in-line offset configuration) Temperature Range: -45°C to 90°C [-45°F to 194°F]Material: Tin-plated aluminum body with high dielectric strength plastisol insulation
Browning® 1223395 Minimum Plain Bore Type C1 Change Gear, 12 Diametral Pitch, 14.5 deg Pressure Angle, 3/4 in W Face, 26 Teeth, 2.167 in Dia Pitch, 1 in Dia Bore, Steel
Browning® offers a comprehensive line of off the shelf gears, including spur, miter and bevel as well as change gears. These are available in 20 deg pressure angle from 20 to 4 diametral pitch and 14.5 deg pressure angle from 48 to 3 diametral pitch. They are all designed to increase output, reduce costs and avoid the need for custom specials.
CONSOLIDATED BRG MI-20 MI Needle Roller Bearing, 1-1/4 in Dia Bore, 1-1/2 in Dia Outside, 1-1/4 in W
CONS MI-20 MI Needle Roller Bearing, 1-1/4 in Dia Bore, 1-1/2 in Dia Outside, 1-1/4 in W
DeWALT® 7404SD1-PWR SD1 Expansion Wedge Anchor, 1/4 in Dia, 3-1/4 in OAL, 2-1/4 in L Thread, Carbon Steel, Zinc Plated
The Power-Stud anchor is a fully threaded, torque-controlled, wedge expansion anchor. It is available in threaded, rod hanger and tie-wire versions suitable for applications in solid concrete and grout filled concrete masonry. The carbon steel threaded version is suitable for a variety of applications. The drill bit diameter necessary for proper installation is the same as the anchor diameter.
5-J-3/4 S-flex Shaft Coupling Half 3/4"
S-FLEX SHAFT COUPLING HALF 3/4" INCH-LOV5J3/4 >
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Inch-type LRB series Inner Rings offer shaft diameters from 3/8 to 3-3/4 in and oil-hole versions for easier lubrication.
