Wall Mounted Drinking Fountains
Halsey Taylor® HAC8FS-Q Non-Filtered Barrier Free Water Cooler, 8 gph Flow Rate, Push Bar Operation, Refrigerated Chilling, Domestic
Self-contained, electric refrigerated wall-mounted non-filtered water cooler easily accessible to physically challenged individuals. HAC8FS-Q deliver 8 gph of 50 deg F drinking water at 90 deg F ambient air and 80 deg F inlet water. Exclusive one-piece, chrome-plated two-stream Double Bubblerâ„¢ with nonremovable anti-squirt feature and integral hood. Automatic stream height regulator is located inside unit to prevent tampering. Includes self-closing, light touch front and side push bar actuation with raised letters for the visually impaired. Type 300 series stainless steel cooler top, with satin finish resists stains. Contourâ„¢ed to insure proper drainage. The manufacturer shall certify the unit to meet the requirements of NSF/ANSI 61 and 372, UL 399 and CAN/CSA 22.2 No. 120.
Recently Viewed
97-DB 12/24-V BACK-UP ALARMS-NASBA1A>
Bussmann Bulletâ„¢ ECSR40 Current Limiting Time Delay Fuse, 40 A, 600 V, 200 kAIC Interrupt, RK5 Class, Cartridge Body
Edison's UL Class RK5 dual-element, time-delay fuses provide economical solutions to overcurrent protectioni. Available in both 250Vac and 600Vac, with 200kA RMS Sym interrupting ratings and sizes ranging from 0 to 600 amp.
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
FYH® NA211 34 NA Series Cylindrical Insert Bearing, 2-1/8 in Dia Bore, 2.81 in W, 43.4 kN Dynamic/29.4 kN Static Load
FYH® NA211 34 NA Series Cylindrical Insert Bearing, 2-1/8 in Dia Bore, 2.81 in W, 43.4 kN Dynamic/29.4 kN Static Load
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
The Crosby G-209 1/4" is a premium, high-strength screw pin anchor shackle designed for quick, temporary connections in tie-down, towing, suspension, or lifting applications. It features an industry-standard 0.5-ton (1,100 lbs) working load limit (WLL) and is instantly recognizable by Crosby's trademark Red Pin®
