1837-251 NIBCO PLUMBING PRODUCTS
2" X 1-1/2" S-80 CPVC SXS BUSHING-NIB1837251 >
Recently Viewed
2" X 1-1/2" S-80 CPVC SXS BUSHING-NIB1837251 >
Browning® 767345 VPS 100 Intermediate Duty Pillow Block Ball Bearing, 1-1/2 in Dia Bore, 4-7/8 to 5-7/8 in L Bolt Center-to-Center, 2 in Base to Bore Centerline, 7-1/8 in OAL x 4 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
Loctite® 55™ Pipe Sealing Cord is a general purpose threaded pipe and fitting sealant. It is a non-curing, coated multifilament cord that seals out air and other common gases and fluids. It comes in a handy container with a built-in cutter to easily apply the proper amount of cord. Loctite® 55™ is recommended for sealing metal and plastic tapered pipe threads and fittings up to 4 in NPT. It has a temperature resistance up to 300 deg F.
Crosby® 1016055 G-402-3/8 Regular Swivel, 2250 lb Load, 3/8 in Trade, Forged Steel, 0.94 in, 1.5 in x 1-1/4 in Eye
Crosby® 1016055 G-402 Regular Swivel, 2250 lb Load, 3/8 in Trade, Forged Steel, 0.94 in, 1.5 in x 1-1/4 in Eye
Dixon® MA150 King™ Short Shank Suction Coupling, 1-1/2 in Nominal, NPSM End Style, Domestic
Dixon® MA150 King™ Short Shank Suction Coupling, 1-1/2 in Nominal, NPSM End Style, Domestic
Sioux Chief 828-2PK Shower Module Drain, 2 in Nominal, Push-On Connection, 4-1/4 in, PVC Drain
Sioux Chief 827 or 828 series shower module drain shall be used where necessary in drainage systems. Shower drain shall have an outer locknut design with compression gasket connection for Sch. 40 ABS/PVC pipe. Snap-in strainer shall meet all applicable load and flow requirements for intended use. Designed in accordance with ASME A112.18.2-2005/CSA B125.2-05.
