206288 DO-IT-BEST/HWI PRODUCTS
1/16" OFFSET SLIDING GLASS DOOR HANGER - JWH206288 >
Recently Viewed
1/16" OFFSET SLIDING GLASS DOOR HANGER - JWH206288 >
BBI 847242 Partially Threaded Cap Screw, 7/16-14, 4 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 847242 Partially Threaded Cap Screw, 7/16-14, 4 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BrowningĀ® 1045590 VP Series Type 2 Variable Pitch Sheave, 1-1/8 in Finished Bore, 5.95 in OD, 1 Groove, 4.4 to 5.4 in (A/4L)/4.7 to 5.9 in (B/5L/5V) Dia Pitch, 7/8 to 1-1/4 in W Face
The principle of a variable pitch sheave is that the threaded angular faced discs forming the V-shaped groove in which the belt rides are movable. VP sheaves consist of a male with a threaded barrel, and a female with a threaded bore. The male section with threaded barrel has flat surfaces at 180 deg increments that allow a flat surface for the setscrew to mate with. When the discs are moved toward each other, the belt rides higher in the groove and the pitch diameter of the sheave is larger which increases the driven speed. When the discs are moved away from each other, the belt rides lower and the pitch diameter is smaller decreasing the driven speed. The common term for this speed adjustment is called number of turns open from closed position.
BBI 710048 Shoulder Screw, Round Socket Head, 18-8 Stainless Steel, 3/8 in Dia x 3/4 in L Shoulder, 5/16-18
BBI 710048 Shoulder Screw, Round Socket Head, 18-8 Stainless Steel, 3/8 in Dia x 3/4 in L Shoulder, 5/16-18
Flex-HoneĀ® BC3432 BC Series Small Diameter Standard Duty Flexible Cylinder Hone, 3/4 in Dia Bore, 2-1/2 in L Abrasive, 8 in OAL, 320 Grit
The BC Series Flex-HoneĀ® tool is designed for use on any type or size of cylinder from 4 mm up to 3 in Dia. This cylinder hone is designed for surface finishing and cross hole deburring in brake cylinders, wheel cylinders, hydraulics, pneumatics and valve guides.
Dichtomatik N70214 O-Ring, 214 Dash Number, 0.984 in ID x 1.262 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
