Browning® PB9005 Taper Bore Bushing Kit, 1-1/16 in ID x 1-7/16 in OD Dia Bushing, For Use With TorqTaper® Plus Size 107SMTP Shaft Mount Speed Reducer, Ductile Iron
Many accessories accompany the Browning® shaft mount reducer. These accessories are designed to provide installation flexibility, improved performance and safety.
-
BrandBrowning®
-
UPC662288910602
-
Manufacturer Part NumberPB9005
-
CountryUSA
-
Bushing Diameter1-1/16 in ID x 1-7/16 in OD
-
MaterialDuctile Iron
-
TypeTaper Bore
-
Dimensions3-1/4 in OD x 3-7/8 in L
-
Specifications3-7/8 in Length Through Bore, 3-1/4 in OD
-
Suitable For Use WithTorqTaper® Plus Size 107SMTP Shaft Mount Speed Reducer
- Exclusive Taper Bushing - Single TorqTaper Bushing installs from either side of the unit for easy on - easy off mounting, with stabilizer ring
- Standard Bearings - Commercially available Tapered Roller Bearings provide maximum overhung load capacity
- Key furnished
-
Alternative Part Number107TBP101
-
UNSPSC26111524
-
Package DescriptionEACH
-
Warranty1 Year
-
Warranty Information
-
Catalog
-
Specification Sheet
Recently Viewed
Browning® PB9005 Taper Bore Bushing Kit, 1-1/16 in ID x 1-7/16 in OD Dia Bushing, For Use With TorqTaper® Plus Size 107SMTP Shaft Mount Speed Reducer, Ductile Iron
Many accessories accompany the Browning® shaft mount reducer. These accessories are designed to provide installation flexibility, improved performance and safety.
3/8" -7/8" CC-06" HOSE CLAMPS-MURGS6 >
1/4" -HOSEX14-MM DIN FEMALE-MHDE0414FML >
Browning® Classical Gripbelt® 1026434 AK Series Type 2 Single Groove Sheave, Finished Bore, 7/8 in Dia Bore, 3.95 in OD, 3.9 in (A)/3.36 in (3L) Dia Pitch, 3/4 in W Face
Browning® Classical Gripbelt® 1026434 AK Series Type 2 Single Groove Sheave, Finished Bore, 7/8 in Dia Bore, 3.95 in OD, 3.9 in (A)/3.36 in (3L) Dia Pitch, 3/4 in W Face
10" X 18" X 1" AIR FILTER - GLATA10181 >
Drillco 445E140 4450E Imperial Hand Reamer, 5/8 in Dia x 7 in OAL, Square Shank, Spiral Flute
Hand Reamers are widely used for final sizing of drilled holes. The square on the shank end is suitable for holding in a tap wrench or vise. The cutting edge is ground with a starting taper to provide easy entry.
