Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
-
BrandChicago Hardware
-
Manufacturer Part Number12988 6
-
CountryUSA
-
MaterialHeat Treated Drop Forged Steel
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypeShoulder Pattern Threaded
-
Working Load9000 lb
-
Shank Length2-1/2 in
-
Shank TypeStandard
-
Diameter - Thread Size1-8
-
Inside Eye Diameter1-13/16 in
-
Outside Eye Diameter3-9/16 in
-
Overall Length7 in
- NO 30 shoulder pattern
- 2250 lb working load limit for 45 deg pull angular lift
-
UNSPSC31161610
-
Package Description1/PK
Recently Viewed
Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
3/8" X 2" GOLD HD OVAL DIE SPRINGS-LANSHDO375200 >
ASP-125-2-SSS Industry Standard Clamping Collar, 2-Piece Construction, 1-1/4 in ID x 2-1/16 in OD x 1/2 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
DOUBLE SHIELDED BALL BEARINGS -GUL16332Z >
24 TOOTH SPROCKETS FOR #40 CHAIN
