Gates® Power Transmission Micro-V® 280J10 Heavy Duty V-Belt, J Section, 3/32 in W Top, 28 in L Outside, 5/32 in THK, Chloroprene
Exclusive truncated (shortened) profile gives Gates® Micro-V® belts increased flexibility, reduced heat buildup and allows performance at higher speeds on smaller diameter sheaves.
-
BrandGates® Power Transmission
-
UPC072053255010
-
Manufacturer Part Number280J10
-
CountryUSA
-
Thickness5/32 in
-
MaterialChloroprene
-
Top Width3/32 in
-
Reinforced MaterialPolyester
-
TypeHeavy Duty
-
Minimum Pulley Diameter3.183 in
-
Section SizeJ
-
Series9171
-
Number of Ribs10
-
Outside Length28 in
- Fiber reinforced ribs for excellent wear resistance
- High modulus, low stretch tensile member for added strength and dependability
- Smooth running for minimal vibration at high speeds
- Oil and heat-resistant, static conductivity
-
Alternative Part Number917102810
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsARPM/RMA IP-3-2/IP-3-3
-
Specification Sheet
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
Gates® Power Transmission Micro-V® 280J10 Heavy Duty V-Belt, J Section, 3/32 in W Top, 28 in L Outside, 5/32 in THK, Chloroprene
Exclusive truncated (shortened) profile gives Gates® Micro-V® belts increased flexibility, reduced heat buildup and allows performance at higher speeds on smaller diameter sheaves.
2" X 4" BLACK NIPPLE-JPW2X4BN >
1-1/2" SCH-80 CPVC FEMALE ADAPTER-NIB1835015 >
2 -MALE PIPE THREADX5 BLACK NIPPLE
Browning® 767893 VPLE 200 Normal Duty Pillow Block Ball Bearing, 1-3/4 in Dia Bore, 5-1/4 to 6-1/16 in L Bolt Center-to-Center, 2-1/16 in Base to Bore Centerline, 7-3/8 in OAL x 4-3/16 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
Browning® 767855 VPLE 200 Normal Duty Pillow Block Ball Bearing, 1-3/8 in Dia Bore, 4-5/8 to 5-3/8 in L Bolt Center-to-Center, 1-13/16 in Base to Bore Centerline, 6-3/4 in OAL x 3-5/8 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
