Gates® Power Transmission Polyflex® 7M825 Light Duty V-Belt, 7M Section, 9/32 in W Top, 32.48 in L Outside, 7/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
-
BrandGates® Power Transmission
-
UPC072053302141
-
Manufacturer Part Number7M825
-
CountryUSA|Canada
-
Temperature Range-65 to 180 deg F
-
Thickness7/32 in
-
MaterialHigh Modulus Polyurethane
-
Top Width9/32 in
-
Reinforced MaterialPolyester
-
TypeLight Duty
-
Minimum Pulley Diameter2.546 in
-
Section Size7M
-
Series8903
-
Number of Ribs1
-
Outside Length32.48 in
- High modulus polyurethane compound resists fatigue, wear, ozone and most environmental conditions
- Precise casting method eliminates layers and overlaps for smooth running and low vibration
- Ribbed backing provides greater lateral stability and relieves bending stress
- Unique 60 deg angle polyurethane construction transmits greater loads at higher speeds in less space than conventional V-belts
-
Alternative Part Number89030825
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsRMA Standard
-
Instruction/Installation Manual
-
Specification Sheet
-
Catalog
Recently Viewed
Gates® Power Transmission Polyflex® 7M825 Light Duty V-Belt, 7M Section, 9/32 in W Top, 32.48 in L Outside, 7/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
.750" X 1.125" X .156" OIL SEALS-TCM07111VC >
MORSE® 57272 5946 Center Cutting Double End Stub Length End Mill, 1/8 in Dia Cutter, 1/4 in Length of Cut, 4 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Bright
MORSE® 57108 5895 Center Cutting Double End Regular Length End Mill, 1/8 in Dia Cutter, 3/8 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 3-1/8 in OAL, Bright
United Abrasives-SAIT 1AX Blue Line™ 57510 Portable Semi-Friable Coated Abrasive Belt, 3 in W x 24 in L, 220 Grit, Very Fine Grade, Aluminum Oxide Abrasive, Cotton Backing
TRAKROL® bearings feature black oxide treated bearing steel. They utilize either a precision ball or tapered roller bearing insert for longer operating life under combination radial and thrust loads. The capacity for combination loads allows the TRAKROL® bearing to be available in plain (cylindrical), V-groove and flanged outside diameter in both stud and yoke styles. Small sizes less than 3 in outside diameter or point diameter use sealed ball bearing inserts. They also use a NYLAPLATE® seal for additional protection. Stud type configurations utilize a metal end plug seal on the roller face providing a long lasting seal. Both bearing types provide a large internal grease reservoir along with special sealing. This makes TRAKROL® bearings an excellent choice where reduced maintenance is required.
