Gates® Power Transmission Hi-Power® II CC96 Banded Heavy Duty Double V-Belt, CC Section, 7/8 in W Top, 100 in L Outside, 23/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
-
BrandGates® Power Transmission
-
UPC072053208245
-
Manufacturer Part NumberCC96
-
CountryUSA|Canada
-
Thickness23/32 in
-
MaterialEPDM
-
Top Width7/8 in
-
Reinforced MaterialFlex-Bonded Polyester
-
TypeBanded Heavy Duty
-
Minimum Pulley Diameter7.958 in
-
Section SizeCC
-
Series9054
-
Number of Ribs1
-
Outside Length100 in
- Flex-bonded cords are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration
- The Flex-Weave® cover is constructed for longer cover life, providing extended protection to the core of the belt from oil, dirt and heat
- Gates® curves provide proper cord support and full contact with the sheave groove for uniform loading, uniform wear and increased belt life
-
Alternative Part Number90540096
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsARPM/RMA IP-3-2/IP-3-3
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Gates® Power Transmission Hi-Power® II CC96 Banded Heavy Duty Double V-Belt, CC Section, 7/8 in W Top, 100 in L Outside, 23/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
1-5/8" -ID LOW PILLOW BLOCK UNIT-MBUVPLE226 >
Drillco 72A164C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1 in Dia Cutter, 1-1/2 in Length of Cut, 2 Flutes, 1 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
Carborundum® CARBO GOLD™ 05539509277 Small Diameter Cut-Off Wheel, 2 in Dia x 0.035 in THK, 1/4 in Center Hole, A60 Grit, Aluminum Oxide Abrasive
MORSE® 43276 1895 Double End Non-Center Cutting Regular Length End Mill, 7/16 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 1/2 in Dia Shank, 4-1/8 in OAL, Bright
Gates® Power Transmission Hi-Power® II CC75 Banded Heavy Duty Double V-Belt, CC Section, 7/8 in W Top, 79 in L Outside, 23/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
