ASP-400-2-S Industry Standard Clamping Collar, 2-Piece Construction, 4 in ID x 5-1/4 in OD x 7/8 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
-
BrandClimax
-
UPC044861634790
-
Manufacturer Part NumberG2SC-400-B
-
CountryUSA
-
FinishBlack Oxide
-
MaterialSteel
-
TypeIndustry Standard
-
Construction2-Piece
-
Screw Size3/8-24 UN-3A x 1 in
-
Width7/8 in
-
SeriesG2SC
-
Inside Diameter4 in
-
Outside Diameter5-1/4 in
- Easily installed where major disassembly would otherwise be required
- Greater axial holding power than setscrew or 1-piece clamping collars
- Effective on hard and soft shafts
- Without recessed screw
- Design fully engages the shaft without marring
-
UNSPSC31162811
-
Package DescriptionEACH
-
Standards/ApprovalsASTM A108|ASTM A574 Cap Screw
-
Specification Sheet
-
Line Drawing
Recently Viewed
ASP-400-2-S Industry Standard Clamping Collar, 2-Piece Construction, 4 in ID x 5-1/4 in OD x 7/8 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
3/4" -FEMALE PIPE THREADX3/8" -FEMALE PIPE THREAD BLACK REDUCER-JPW3/4X3/8BR >
Stanley Proto J1193T-A 12 Point Ratcheting Box Wrench 1/2 X 9/16-PROJ1193TA
HCI Preferred Supplier GE214NPT 2-Way High Pressure Ball Valve, 1/4 in Nominal, NPTF End Style, Steel Body, Full Port, Buna-N® O-Ring Softgoods
HCI Preferred Supplier GE214NPT 2-Way High Pressure Ball Valve, 1/4 in Nominal, NPTF End Style, Steel Body, Full Port, Buna-N® O-Ring Softgoods
Dichtomatik S70113 O-Ring, 113 Dash Number, 0.549 in ID x 0.755 in OD, Silicone Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
1-OZ MAGENTA PAINT COLORANT-BLPM >
