ASP1312-S Industry Standard Clamping Collar, 2-Piece Construction, 1-5/16 in ID x 2-1/8 in OD x 9/16 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
-
BrandClimax
-
UPC044861634417
-
Manufacturer Part NumberG2SC-131-B
-
CountryUSA
-
FinishBlack Oxide
-
MaterialSteel
-
TypeIndustry Standard
-
Construction2-Piece
-
Screw Size1/4-28 UN-3A x 3/4 in
-
Width9/16 in
-
SeriesG2SC
-
Inside Diameter1-5/16 in
-
Outside Diameter2-1/8 in
- Easily installed where major disassembly would otherwise be required
- Greater axial holding power than setscrew or 1-piece clamping collars
- Effective on hard and soft shafts
- Without recessed screw
- Design fully engages the shaft without marring
-
UNSPSC31162811
-
Package DescriptionEACH
-
Standards/ApprovalsASTM A108|ASTM A574 Cap Screw
-
Specification Sheet
-
Line Drawing
Recently Viewed
ASP1312-S Industry Standard Clamping Collar, 2-Piece Construction, 1-5/16 in ID x 2-1/8 in OD x 9/16 in W, Steel
Black Oxide Plated Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
Browning® 3750676 Taper Bore Bushing, 2-7/8 in Dia Bore, 4-1/4 in Dia Barrel, 3 in OAL
Browning® 3750676 Taper Bore Bushing, 2-7/8 in Dia Bore, 4-1/4 in Dia Barrel, 3 in OAL
1-1/2" SCHEDULE 80 SLIP-ON FLANGES-FIT11/2XHBWFSLIP >
Jones Stephens™ C02050 Enduro Closet Bolt, 2-1/2 in OAL, Plastic
Browning® 1296474 T45L Automatic Torque Limiter, 1-3/8 in Finished Bore, 4-1/2 in OD, 2800 in-lb (1-Spring)/4900 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
Midland Industries 80-003 Dry Standard Pressure Gauge, 0 to 60 psi, 1/4 in Connection, 2 in Dial
