Sealmaster 1-1/2"-ID SPH/OD INSERT BEARINGS SEA 2-18-T
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
-
BrandSealmaster®
-
UPC662461029152
-
Manufacturer Part Number705317
-
CountryUSA
-
Load Capacity7340 lb Dynamic/4467 lb Static
-
Cage MaterialBrass
-
Temperature Rating-20 to 220 deg F
-
FinishBlack Oxide Coated
-
Maximum Speed5850 rpm
-
Closure TypeDouble Seal
-
TypeNon-Expansion Standard Duty Straight Bore
-
Seal MaterialFelt
-
Width2 in
-
Bearing MaterialSteel
-
Outside Diameter3.1496 in
-
Bore Diameter1-1/2 in
- Wide outer ring
- Lock pin and dimple system
- The felt seal with flinger provides a tight labyrinth seal which retains lubrication and acts as a filter to exclude contamination
- Skwezloc® is a concentric locking collar clamp design that results in near perfect concentricity of the shaft to the bearing bore and maintains near perfect ball path roundness
- Zone hardened inner race
- Land riding retainer
- Lithium complex NLGI #2 grease with an EP additive
-
Alternative Part Number2-18T
-
UNSPSC31171537
-
Package DescriptionEACH
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
MORSE® 58854 5957 Ball Nose Center Cutting Long Length Single End End Mill, 3/8 in Dia Cutter, 1-1/8 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 3 in OAL, Bright
Weiler® 08178 ST-10 Heavy-Duty Wheel Brush, 10 in Dia Brush, 3/4 in W Face, 0.014 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 3/4 in Arbor Hole
Weiler® 08178 ST-10 Heavy-Duty Wheel Brush, 10 in Dia Brush, 3/4 in W Face, 0.014 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 3/4 in Arbor Hole
24 MEDIUM POLY FLOOR BRUSHES-MDB231240 >
G.L.HUYETT™ HLPG-0375-2000 Drilled Imperial Clevis Pin, 3/8 in Dia x 2-11/32 in OAL, 2 in L Usable, Low Carbon Steel, Zinc Clear
G.L.HUYETT™ HLPG-0375-2000 Drilled Imperial Clevis Pin, 3/8 in Dia x 2-11/32 in OAL, 2 in L Usable, Low Carbon Steel, Zinc Clear
