Master Locks 1"-JAW SAFETY LOCKOUT CLAMPS MAS 420
Steel Lockout Hasp - 1 in (2.5cm) jaw. Lockout by multiple workers at each lockout point. Keeps equipment inoperative while repairs or adjustments are made. Control cannot be turned on until last worker's padlock is removed from hasp. Heavy gauge steel jaw with red vinyl coated handle. Dimensions are 1-3/4 in x 4-1/2 in (4.4cm x 11.4cm) with 1 in (2.5cm) inside jaw Dia, holds up to 6 padlocks. Shelf pack quantity 12, master carton quantity 72. commercial packaging.
-
BrandMaster Lock®
-
UPC071649442407
-
Manufacturer Part Number420
-
CountryUSA|Canada
-
MaterialSteel
-
Maximum Number of Padlocks6
-
ColorRed
-
TypeScissor Snap-On
-
Width1-3/4 in
-
Length4-1/2 in
-
Padlock Shackle Maximum Diameter9/32 in
- The master Lock® #420 steel safety lockout hasp features a 1 in (25mm) inside jaw diameter and can hold up to six padlocks
- Lockout by multiple workers at each lockout point
- Keeps equipment inoperative while repairs or adjustments are being made
- Control cannot be turned on until last worker's safety padlock is removed from hasp
- Heavy gauge steel jaw with red vinyl coated handle
| Competitor Name | Cross-Reference Number |
|---|---|
| Berkshire eSupply | KP90420 |
| Fastenal | 1000180 |
-
UNSPSC39121903
-
Package DescriptionEACH
Recently Viewed
Steel Lockout Hasp - 1 in (2.5cm) jaw. Lockout by multiple workers at each lockout point. Keeps equipment inoperative while repairs or adjustments are made. Control cannot be turned on until last worker's padlock is removed from hasp. Heavy gauge steel jaw with red vinyl coated handle. Dimensions are 1-3/4 in x 4-1/2 in (4.4cm x 11.4cm) with 1 in (2.5cm) inside jaw Dia, holds up to 6 padlocks. Shelf pack quantity 12, master carton quantity 72. commercial packaging.
Greenlee® 625-7/8 Hole Cutter, 7/8 in Dia, 8 ga D Cutting, Tungsten Carbide Tip Cutting Edge
Greenlee® 625-7/8 Hole Cutter, 7/8 in Dia, 8 ga D Cutting, Tungsten Carbide Tip Cutting Edge
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
