JASON 367L050 3/8-" L PITCH STANDARD TIMING BELT. 36.7 " PITCH LENGTH, 98 TEETH 12.7 MM WIDTH
SYNTHETIC RUBBER TIMING BELT. COMFORMS TO RMA ENGINEERING STANDARD. TIMING BELTS ARE MEASURED BY LENGTH, TOOTH PITCH, THEN WIDTH. THE FIRST NUMBER IS THE LENGTH; THE LETTER AND SOMETIME NUMBER REFER TO THE TOOTH AND THE FINAL NUMBER IS THE WIDTH. STANDARD TIMING TOOTH PROFILE, H; FIBERGLASS TENSIILE MATERIAL; RUBBER OUTER MATERIAL
-JAS367L050 >
Recently Viewed
JASON 367L050 3/8-" L PITCH STANDARD TIMING BELT. 36.7 " PITCH LENGTH, 98 TEETH 12.7 MM WIDTH
SYNTHETIC RUBBER TIMING BELT. COMFORMS TO RMA ENGINEERING STANDARD. TIMING BELTS ARE MEASURED BY LENGTH, TOOTH PITCH, THEN WIDTH. THE FIRST NUMBER IS THE LENGTH; THE LETTER AND SOMETIME NUMBER REFER TO THE TOOTH AND THE FINAL NUMBER IS THE WIDTH. STANDARD TIMING TOOTH PROFILE, H; FIBERGLASS TENSIILE MATERIAL; RUBBER OUTER MATERIAL
-JAS367L050 >
Brady® 65688 1-Pole Snap-On Circuit Breaker Switch Lockout Device, For Use With 120 V AC Multi-Pole Tie Bar Breaker with Hole in Switch Tongue, LOTO-15 Nylon, Red
Snap-On Breaker Lockouts are quick and easy to install - just snap in place and apply lock. Designed for 120V breakers that have holes in the switch tongue.
S1-1-15/16" SPLIT TAPER BUSHING, 1-15/16" BORE, 1/2" X 1/4" KEYWAY-BRWS1115/16 >
PERMAGLIDE BEARING-INAPAPZ0808P10>
3/4" -ID SPECIAL AG BEARING-GUL206GGH >
Dichtomatik N70121 O-Ring, 121 Dash Number, 1.049 in ID x 1.255 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
