3-L-680 JASON INDUSTRIAL PRODUCTS
FHP V-BELT-JAS3L680 >
Recently Viewed
FHP V-BELT-JAS3L680 >
MORSE® 44206 4552 Center Cutting Extra Long Length Single End End Mill, 3/4 in Dia Cutter, 4 in Length of Cut, 4 Flutes, 3/4 in Dia Shank, 6-1/4 in OAL, Bright
Coilhose® PFE61004T Flexeel® PFE6 Straight Air Hose With Reusable Strain Relief, 3/8 in, 1/4 in MPT Rigid, 100 ft L, 200 psi at 70 deg F, Reinforced Polyurethane, Domestic
Flexeel® reinforced polyurethane is an extremely flexible coil with excellent memory, a small bend radius, and a tight coil diameter that reduces work and storage space. Flexeel® coil is the original reinforced polyurethane coil. This hose is extremely lightweight and is extruded with an inner-layer, a layer of reinforced braiding, and an outside jacket. This extrusion process yields an "integral piece" that ensures the integrity of the hose over long periods of use. All of this yields a strong, durable hose with an increased working pressure. These units are equipped with reusable fittings that allow in-field repairs if necessary. Flexeel® coils feature straight sections measuring 16" at the tool end, and 8" at the supply end, eliminating the need for an additional whip hose.
Powersâ„¢ TempTAPâ„¢ 115 Traditional Standard Lavatory Faucet, 1 Handles, 2 gpm Flow Rate
Series 105 and 115 TempTAPâ„¢ thermostatic faucets feature an advanced thermal actuator to provide the latest in thermal protection. The single-lever cartridge, with integral ceramic discs, provides both temperature and volume control. TempTAPâ„¢ automatically mixes hot and cold water to deliver pre-set water within a specific range. In the event of cold water failure, the thermal actuator virtually shuts off the flow of hot water. TempTAPâ„¢ is listed to ASSE 1070, IAPMO cUPC, and NSF 61 Section 9 Annex G.
Drillco 72A108C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1/8 in Dia Cutter, 3/8 in Length of Cut, 2 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
12" SHELVING END BRACE
