Varnishes
Krylon® Kamar® 1312 Varnish, 11 oz, Liquid, 2 hr Curing
Recently Viewed
Littelfuse® POWR-GARD® LLSRK350ID Current Limiting Time Delay Fuse, 350 A, 600 V AC/300 V DC, 200/20 kA Interrupt, RK1 Class, Cartridge Body
The all new LLSRK_ID series fuse is the most advanced Class RK1 fuse available today providing unparalleled performance and protection to modern circuits. The patented Indicatorâ„¢ technology provides instant identification of a blown fuse greatly enhancing system up time, while the precision formed short circuit elements virtually eliminate damage to components from unexpected electrical faults. In addition, the all new solid state overload section has no moving parts, stopping unnecessary fatigue failures commonly found in other spring loaded fuses.
The Starrett 117 Center Punch is made of specially selected steel, hardened and properly tempered. It is well proportioned, nicely finished and has a knurled finger grip. The points are ground at the proper angle to give maximum service, and the tips are accurately centered. 4" (100mm) Length, 1/8" (3mm) Point Diameter.
Type S flanges sizes 6 through 16 are manufactured of high strength cast iron then bored-to-size for slip fit on standard shafts. Size 5 is made of sintered carbon steel. Flanges are easy to install and remove, and are stocked in a wide range of bore sizes. All sleeve materials may be used with type S flanges.
Sealmaster 3-7/16"-ID 4-BOLT BB PILLOW BLOCKS SEA MSFPD-55
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
BBI 360130 Fender Flat Washer, 3/16 in ID x 1-1/4 in OD, Low Carbon Steel
SK-1 QUICK DISCONNECT BUSHING WITH A 1" BORE, 1/4' X 1/8' KEYWAY-BRWSK1 >
