KRYLON GLS BLACK CERAMC ENGINE SPRAYPAINT KRY DE-1613
-
BrandDupli-Color®
-
UPC026916916136
-
Manufacturer Part NumberEDE1613
-
CountryUSA
-
Temperature Rating60 to 92 deg F
-
FinishHigh Gloss
-
Chemical CompositionAcetone, Toluene, Propane, Butane, Carbon Black, Methyl Ethyl Ketoxime
-
FormLiquid
-
ColorBlack
-
VOC Content0.5292
-
Viscosity<7 cSt
-
Container Size12 oz
-
Container TypeAerosol Can
- Features EZ Touch® conical nozzle
- Maximum heat dissipation and high gloss retention
- Ceramic resins resist heat up to 500 deg F
- Resistant to oil and other automotive fluids
- Will not blister, flake, crack or peel
- Dupli-Color® engine enamel will perform to the most rigorous standards of racing, street rod and vehicle restoration enthusiasts
- 0.74 specific gravity
- -20.2 deg F flash point
-
UNSPSC31211501
-
Package Description6/PK
-
Standards/ApprovalsOSHA 29 CFR 1910.1200|NIOSH Approved|SARA 313
-
Instruction/Installation Manual
-
SDS
Recently Viewed
Littelfuse® ATOF® 028707.5L 287 Fast Acting Automotive Fuse, 7.5 A, 32 V DC, 1 kA Interrupt
Developed by Littelfuse® for the automotive industry, the ATOF® fuse has become the original equipment circuit protection standard for foreign and domestic automobiles and trucks. Readily identifiable and easily replaced, this fuse can be specified for a variety of low voltage electronic applications.
LARGE FULL BODY HARNESS-SHOULDER PAD-FRE750AL >
ALAN 12-THHN RED STRANDED WIRE. THE THHN CONDUCTORS ARE PRIMARILY USED IN CONDUIT AS BRANCH CIRCUITS IN COMMERCIAL OR INDUSTRIAL APPLICATIONS.
TYPE THHN IS AVAILABLE STRANDED IN SIZES 14 AWG -750 KCMIT. THE CONDUCTORS ARE SOFT-ANNEALED, STRANDED OR SOLID COPPER AND ARE INSULATED WITH A TOUGH HEAT AND MOISTURE-RESISTANT POLYVINYL CHLORIDE, OVER WHICH A NYLON JACKSON IS APPLIED.
-ALE12THHNRED >
REAR HANGER, NO BUSHING, SINGLE AXLE ONLY - RED930033X>
Drillco 72A140C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 5/8 in Dia Cutter, 1-1/4 in Length of Cut, 2 Flutes, 5/8 in Dia Shank, 3-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
