Results 1 - 16 of 16
Grid

Sioux Chief 490-11322 Closet Flange Floor Support

Sioux Chief metal hanger strap shall be used where necessary to support CTS, IPS or DWV pipe. Metal strap shall be made with galvanized or copper-plated steel and installed in accordance with national codes pertaining to hanger spacing and slope requirements. Metal hanger strap shall feature 1/4 or 3/16 in pre-drilled pilot holes in alternating pattern and strap shall be 3/4 in wide.

Sioux Chief metal hanger strap shall be used where necessary to support CTS, IPS or DWV pipe. Metal strap shall be made with galvanized or copper-plated steel and installed in accordance with national codes pertaining to hanger spacing and slope requirements. Metal hanger strap shall feature 1/4 or 3/16 in pre-drilled pilot holes in alternating pattern and strap shall be 3/4 in wide.

Sioux Chief 634-112 Straight Flexible Water Heater Connector, 3/4 in, FNPT x FNPT Swivel, 12 in L, Copper

Sioux Chief 827 or 828 series shower module drain shall be used where necessary in drainage systems. Shower drain shall have an outer locknut design with compression gasket connection for Sch. 40 ABS/PVC pipe. Snap-in strainer shall meet all applicable load and flow requirements for intended use. Designed in accordance with ASME A112.18.2-2005/CSA B125.2-05.

Sioux Chief 840 series general-purpose floor drain shall be used where necessary in drainage systems. Floor drain shall have an ABS/PVC body with SCH 40 hub connection in accordance with ASTM D2661/D2665 and connect to pipe via solvent weld joint. Strainer shall be heel-proof, 19-gauge 430 stainless steel and meet applicable load requirements for intended use.

Installed closet flanges shall be Sioux Chief 890 Series cast iron closet flange. Closet flange shall have three screw holes for securing to floor, and two closet bolt slots. Internal neoprene compression gasket shall create seal when lock ring is tightened via three stainless steel bolts. Flange shall have an integral neoprene test cap and be UPC listed.

Sioux Chief 889 series full flush closet flanges shall be used where necessary in drainage systems. Flange shall allow 1-1/2 in offset in any direction and have a full-swivel, corrosion-proof stainless steel ring with sufficient holes for securing to floor and slots for inserting closet bolts. Flange shall have an offset inner diameter area properly sized to allow full 3 in spherical flow for complete drainage and clog resistance. Flange shall have a 3 in SCH 40/STD hub connection which conforms to ASTM D2665 (PVC). Closet flange shall be UPC listed. Always fasten closet flanges to the floor.

My Wishlist
Compare

Sioux Chief PushTite™ 887-GPTMK Installation Kit, Domestic

Plumbing Drains & Traps Accessories
$19.48

Sioux Chief PushTite™ 887-GPTMK Installation Kit, Domestic

My Wishlist
Compare

Sioux Chief Raise-A-Ring™ 886-R Spacer/Extension Ring, ABS

Plumbing Drains & Traps Accessories
$3.68

Installers use Sioux Chief's spacer and repair rings to repair or adapt closet flanges for specific applications, such as when new or thicker flooring is added. The Quick Spacer™ installs under the flange, while the Raise-A-Ring™ is typically set on top of the flange, and can be stacked if necessary. For repairs to cracked or broken flanges, installers can fit Sioux Chief's stainless steel Ringer™ over the damaged flange and fasten it to the floor. Also available is a two-piece repair ring, designed to replace rusted or broken metal swivel rings without replacing the plastic portion of the flange.

Jones Stephens™ S26004 Saddle Tee Kit, 3 x 2 in, PVC Clamp, Domestic

Sioux Chief SmartSaddle™ 891-0412P DWV Saddle Tee Fitting, 1-1/2 Hub x 2 in Spigot, Stainless Steel, Import

Jones Stephens™ S26005 Saddle Tee Kit, 4 x 2 in, PVC Clamp, Domestic

Sioux Chief TKO™ 886-4PT 1-Piece Closet Flange, 4 x 4 in Pipe, PVC, Domestic

At Sioux Chief we design our open flanges with the same care and precision as we do the TKO. Contractors have found the open flange to be a cost effective alternative in those instances where a test cap is not needed. These include installations after the system is tested or where no testing is performed. We complement our complete line of open flanges with five different connection types, in ABS or PVC, 1-piece or with a corrosion-resistant, 430 stainless steel swivel ring.

At Sioux Chief we design our open flanges with the same care and precision as we do the TKO. Contractors have found the open flange to be a cost effective alternative in those instances where a test cap is not needed. These include installations after the system is tested or where no testing is performed. We complement our complete line of open flanges with five different connection types, in ABS or PVC, 1-piece or with a corrosion-resistant, 430 stainless steel swivel ring.

Recently Viewed

Apex® MB-13MM23 Long Length Magnetic Socket, 3/8 in Square Drive, 13 mm Hex Socket, 6 Points

My Wishlist
Compare

Master Locks #8 MASTER LOCK MAS 8-D

Deadbolt Locks
$9.54

#8 MASTER LOCK-MAS8D >

My Wishlist
Compare

60102 HOLO-KROME

FLAT HEAD
$0.58

3/8" X 1-1/4" USS F/H S/H CAPSCREW-HOL60102>

GEARWRENCH offers a wide range of impact products in open stock & sets that are designed to deliver the performance and strength that the professional users require. They are made from chrome molybdenum alloy steel for exceptional strength and durability. Our sockets have a manganese phosphate coating to resist corrosion. The sockets also feature highly visible laser etched markings and a secondary size hard stamping. The sockets feature off-corner loading to reduce fastener rounding. The GEARWRENCH impact product family will allow the professional user to FORGE AHEAD.

My Wishlist
Compare

6612-G B-LINE

WIREWAY
$60.67

6" X 12" TYPE 1 PAINTED SCREW COVER WIREWAY-BLN6612G >

Dodge® 093407QC Flex Module, For Use With Size 48 3.4, 5.4 A QC Coupling

If you need any additional information, prices, availability, etc. please contact us at 1-800-290-9908 or e-mail us at

Footer Menu