Leviton® 13661-SNP Lampholder, 660 W Lamp, 600 V AC, G13 Lamp
Leviton® 13661-SNP Lampholder, 660 W Lamp, 600 VAC, Medium Bi-Pin Fluorescent Lamp
-
BrandLeviton®
-
UPC078477349656
-
Manufacturer Part Number13661-SNP
-
CountryCanada
-
Terminal TypeQuick-Connect
-
MaterialThermoplastic
-
ColorWhite
-
Mounting TypeSnap-In
-
Voltage Rating600 V AC
-
Lamp Base TypeG13
-
Lamp TypeFluorescent
-
Lamp Wattage660 W
- T8 to T12 fluorescent lamp
- Bottom load
- Turn type with lamp lock
- Medium height
- 4 mounting hole
- Compact fluorescent lamp type
-
Alternative Part Number12246583
-
UNSPSC39101605
-
IDEA Index ID12246583
-
Package DescriptionEACH
-
Standards/ApprovalsCSA Certified|UL Listed
-
RoHS
-
Instruction/Installation Manual
Recently Viewed
Leviton® 13661-SNP Lampholder, 660 W Lamp, 600 VAC, Medium Bi-Pin Fluorescent Lamp
Mounted Unit 1-3/4"-ID 2-BOLT TRB PILLOW BLOCKS MBU PBE-920 X 1-3/4
Moline Bearing 19321112 Type E Pillow Block Bearing, 1-3/4 in Dia Bore, 6-11/16 in L Bolt Center-to-Center, 2-1/4 in Base to Bore Centerline, 8-7/8 in OAL x 4-1/2 in OAH
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
Drillco 76A120C 7600 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 5/16 in Dia Cutter, 1 in Length of Cut, 2 Flutes, 5/16 in Dia Shank, 2-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
RIDGID® 40158 Wet Application Filter, For Use With 5 to 20 gal Vacuum Cleaner
RIDGID® 40158 Wet Application Filter, For Use With 5 to 20 gal Vacuum Cleaner
120V 2700/4000LB ELECTRIC WINCH-GOLSA12015AC>
