Leviton® 128 2-Pole 2-Wire Single Lampholder to Twin Lampholder Outlet Adapter, 660 W, 125 V AC, 15 A, E26 Lamp
Leviton® electrical accessories for the home include taps and adapters, nightlights and battery operated lighting. Every electrical accessory is subject to Leviton® strict in-house quality control and must meet or exceed applicable industry standards.
-
BrandLeviton®
-
UPC078477341186
-
Manufacturer Part Number128
-
CountryUSA
-
ColorBrown
-
Type2-Pole 2-Wire Single Lampholder to Twin Lampholder
-
Voltage Rating125 V AC
-
Wattage660 W
-
Amperage Rating15 A
-
Dimensions4 in L x 2 in W x 4 in H
-
Lamp Base TypeE26
| Cross-Reference Number |
|---|
| 515561 |
-
Alternative Part Number9926696
-
UNSPSC39121006
-
IDEA Index ID9926696
-
Package DescriptionEACH
-
Standards/ApprovalsUL Listed|CSA Certified|NOM 057
-
Specification Sheet
Recently Viewed
Leviton® 128 2-Pole 2-Wire Single Lampholder to Twin Lampholder Outlet Adapter, 660 W, 125 V AC, 15 A, E26 Lamp
Leviton® electrical accessories for the home include taps and adapters, nightlights and battery operated lighting. Every electrical accessory is subject to Leviton® strict in-house quality control and must meet or exceed applicable industry standards.
ERB® 19146 Americana® Replacement Brow Pad, For Use With Omega II®, Omega II® Full Brim and Americana® Hard Hat, Nylon/Polyester Foam, Blue, ANSI Z89.1
ERB® 19146 Americana® Replacement Brow Pad, For Use With Omega II®, Omega II® Full Brim and Americana® Hard Hat, Nylon/Polyester Foam, Blue, ANSI Z89.1
ISOSTATIC™ Oilube® 401163 Round Bore Sleeve Bearing, 1/2 in Dia Bore, 1 in OD, 1-1/2 in W
Drillco 200LH21 Left Hand Cut Jobber Length Drill Set, 1/16 in Min Drill Bit, 3/8 in Max Drill Bit, 118 deg Drill Point Angle, 21 Pieces, HSS, Uncoated
200LH drills are used in close center multiple spindle gear driven drilling heads, where adjacent spindles operate alternately left and right hand. They are also used in left hand screw machines. Can be used to drill out broken bolts.
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
FHP V-BELTS-PIX3L140>
