190300 MILWAUKEE DUSTLESS BRUSH
60" 3/8" -MALE TIP STEEL HANDLE-MDB190300 >
Recently Viewed
60" 3/8" -MALE TIP STEEL HANDLE-MDB190300 >
Morse® ZWEDC1014MAT-64-1/2" General Purpose Band Saw Blade, 64-1/2 in L, 1/2 in W x 0.025 in THK, 10/14 TPI, Bi-Metal Body
IKO LRB101412 Inch Series Inner Ring With Oil Groove, 5/8 in ID x 7/8 in OD, 19.3 mm OAW, For Use With BR142212 Machined Type Needle Roller Bearing, High Carbon Steel
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Inch-type LRB series Inner Rings offer shaft diameters from 3/8 to 3-3/4 in and oil-hole versions for easier lubrication.
14" WHITE BUFFING PAD-PAD4014WHI >
Appleton® ETP™ WVS1 Self-Closing Weatherproof Square Box Cover, 4.53 in L x 4.53 in W, Single Receptacle/Switch Cover, Die Cast Zinc
Appleton® ETP™ WVS1 Self-Closing Weatherproof Square Box Cover, 4.53 in L x 4.53 in W, Single Receptacle/Switch Cover, Die Cast Zinc
Tuff-Seal™ Support Grips are designed to hold the weight of cable that is vertical or sloping. Support grips serve an important function; electrical cables must be supported or their dead weight can cause excessive strain or pullout at the connections resulting in power failure. Tuff-Seal™ Support Grips are woven with non-magnetic, tinned bronze wire that absorbs strain and flexing while resisting cable pull-out, flexing and vibration. These grips are available in a variety of eye styles and cable ranges, can be used either indoors or outdoors and will support cable, metal rods and tubing with loads up to 600 lb.
