72172 3/8" Diameterx2-3/4" Socket Head
3/8" DIAMETERX2-3/4" SOCKET HEAD CAP SCREWS-HOL72172 >
Recently Viewed
3/8" DIAMETERX2-3/4" SOCKET HEAD CAP SCREWS-HOL72172 >
Browning® 1224328 Minimum Plain Bore Type C1 Change Gear, 10 Diametral Pitch, 14.5 deg Pressure Angle, 1 in W Face, 24 Teeth, 2.4 in Dia Pitch, 1-1/4 in Dia Bore, Steel
Browning® offers a comprehensive line of off the shelf gears, including spur, miter and bevel as well as change gears. These are available in 20 deg pressure angle from 20 to 4 diametral pitch and 14.5 deg pressure angle from 48 to 3 diametral pitch. They are all designed to increase output, reduce costs and avoid the need for custom specials.
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
2-SPEED HAND PUMP-OMGP1000 >
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
GARVIN® LC50 C-Style Conduit Body With Unit Cover and Neoprene Gasket, 1/2 in Hub, Die Cast Aluminum, Powder Coated
1/2 in C-style conduit bodies are attached to 1/2 in threaded rigid or IMC conduits when a change of direction is required. Their removable cover makes general maintece and wire pulling and feed through easy and convenient. Commonly used for electrical service entrance wires or as an economical convenience box when extra wire capacity is needed. Garvin Industries C-style conduit bodies save time and money by eliminating costly bending of large conduits in order to change the directions of conduit runs. They allow the installer to easily bend wires into the smooth turns. Their powder coated finish and watertight gasket ensure a weatherproof installation. This item has a 2 hr fire rating.
