S-MH-O-1000-350 1" X 3-1/2" Md/hd Oval
1" X 3-1/2" MD/HD OVAL DIE SPRINGS-LANSMHO1000350 >
Recently Viewed
1" X 3-1/2" MD/HD OVAL DIE SPRINGS-LANSMHO1000350 >
Drillco 76A128C 7600 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 7/16 in Dia Cutter, 1 in Length of Cut, 2 Flutes, 7/16 in Dia Shank, 2-3/4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
Dodge® 117705 Stock Bore Taper Lock Bushing, 4-15/16 in Dia Bore, 6.38 in Dia Barrel, 4-1/2 in OAL, Ductile Iron
Dodge® Taper-Lock® bushings are flangeless for clean, compact application. They are engineered with an 8 deg taper and a flush-mounted design with no protruding parts providing secure locking and elimination of wobble.
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. A matching high shoulder is often on the opposite side of the inner ring as well. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. This ball bearing has a 40 deg contact angle. This bearing has a stamped steel cage and is not available with seals or shields. These bearings are non-separable. These bearings have normal tolerances and are not suitable for mounting adjacent to each other to achieve a preload.
10" DECK BRUSH WITH 3" PALMYRA TRIM - MAG1103 >
MINI-PULLER, 1/2" TON 0R 1,100LB LOAD CAPACITY, VERY COMPACT & LIGHTWEIGHT, LOW PULLING FORCE REQUIRED FOR OPERATION, 5FT LIFT-HRHLX0055 >
