9900 7-piece Metric Flex Ratcheting Combination Gear Wrench
7-PIECE METRIC FLEX RATCHETING COMBINATION GEAR WRENCH SET - GRW9900>
Recently Viewed
7-PIECE METRIC FLEX RATCHETING COMBINATION GEAR WRENCH SET - GRW9900>
Crescent® C6CCV Locking Plier With Regular Tips, 2 in, C-Clamp
Ingersoll-Rand 38436721 EDGE Seriesâ„¢ All Season Select Synthetic Lubricant, 1 L
Protect your Ingersoll Rand Air Compressor investment, and increase it's efficiency with this 1/2 Liter all Season synthetic compressor oil. this all temperature blend can be used ALL year to reduce the wear and tear on your compressor. Use of Ingersoll Rand's all Season Select Synthetic Lubricant extends the pump warranty by 1 year.
Irwin® Vise-Grip® Original™ 4935578 Locking Plier, 1-1/2 in Nominal, Classic Trigger Locking, Alloy Steel Curved Jaw, 7 in OAL
Irwin® Vise-Grip® Original™ 4935578 Locking Plier, 1-1/2 in Nominal, Classic Trigger Locking, Alloy Steel Curved Jaw, 7 in OAL
IKO BA148ZOH Inch Series Caged Shell Standard Needle Roller Bearing With Oil Hole and Dust Cover, 7/8 in Dia Bore, 1-1/8 in OD, 1 Row, 1/2 in W, 7440 N Dynamic/10100 N Static Load
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
Koyo TRA-1018 Double Direction Thrust Washer, 15.88 mm ID x 28.58 mm OD, 0.81 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
