FREUDENBERG Simmering® 75040594 B1 Oil Seal, 45 mm ID x 72 mm OD, 10 mm W, NBR Lip, 72 Durometer, Import
FREUDENBERG Simmering® 15X28X5SC-BX B1 Oil Seal, 45 mm ID x 72 mm OD, 10 mm W, NBR Lip, 72 Durometer, Import
-
BrandFREUDENBERG
-
UPC750886257912
-
Manufacturer Part Number75040594
-
CountryUSA
-
Temperature Rating-40 to 100 deg C
-
ColorBlue
-
Width10 mm
-
SeriesB1
-
Inside Diameter45 mm
-
Domestic/ImportImport
-
Durometer72
-
Outside Diameter72 mm
- Spring-loaded sealing lip
- Broad range of applications in every sector of industry
- Metal housing for especially firm and precise seating in the bore
-
Alternative Part Number40412178|15X28X5SC-BX
-
UNSPSC31411705
-
Package Description5/PK
-
Standards/ApprovalsADI Free Certified
-
Specification Sheet
Recently Viewed
FREUDENBERG Simmering® 75040594 B1 Oil Seal, 45 mm ID x 72 mm OD, 10 mm W, NBR Lip, 72 Durometer, Import
FREUDENBERG Simmering® 15X28X5SC-BX B1 Oil Seal, 45 mm ID x 72 mm OD, 10 mm W, NBR Lip, 72 Durometer, Import
Browning® 1296615 T65L Automatic Torque Limiter, 1-15/16 in Finished Bore, 6-1/2 in OD, 4800 in-lb (1-Spring)/8800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
3/8" -NATIONAL PIPE THREAD AIR SWIVELS-JETJAS38 >
Klein® 87916 Boom Strap With Friction Buckle, 54 in L, Nylon
Dichtomatik N70354 O-Ring, 354 Dash Number, 5.1 in ID x 5.52 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
4" STRINGER BEAD TWIST WIRE BRUSH-MAK7432035A>
