Dichtomatik 67013355 O-Ring, 42 mm ID x 46 mm OD, FKM, 80 Shore A Durometer, Import, Custom H-2 x 42-VITON
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number67013355
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter42 mm
-
Domestic/ImportImport
-
Durometer80 Shore A
-
Outside Diameter46 mm
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberV2.00X042
-
Instruction/Installation Manual
-
Catalog
-
Specification Sheet
Recently Viewed
Dichtomatik 67013355 O-Ring, 42 mm ID x 46 mm OD, FKM, 80 Shore A Durometer, Import, Custom H-2 x 42-VITON
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
MARXMAN™ 85095 330QI General Purpose Jobber Length Drill Bit, #41 Drill - Wire, 0.096 in Drill - Decimal Inch, 118 deg Point, HSS, Black Oxide
SINGLE GROOVE 5/8" -ID A-BELT SHEAVES
SINGLE GROOVE 5/8" -ID A-BELT SHEAVES
FYH® UCFX10 31 UCF Cylindrical Flange Mount Ball Bearing Unit, 1-15/16 in Dia Bore, 5-1/8 in L Bolt Center-to-Center, 3/4 in Dia Bolt Circle, 4-Bolt Flange Flange Mount, 6-3/8 in OAL/Dia
FYH® UCFX10 31 UCF Cylindrical Flange Mount Ball Bearing Unit, 1-15/16 in Dia Bore, 5-1/8 in L Bolt Center-to-Center, 3/4 in Dia Bolt Circle, 4-Bolt Flange Flange Mount, 6-3/8 in OAL/Dia
Browning® offers a comprehensive line of off the shelf gears, including spur, miter and bevel as well as change gears. These are available in 20 deg pressure angle from 20 to 4 diametral pitch and 14.5 deg pressure angle from 48 to 3 diametral pitch. They are all designed to increase output, reduce costs and avoid the need for custom specials.
