Dichtomatik 75122141 O-Ring, 17 mm ID x 22 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 17
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number75122141
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter17 mm
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter22 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberN2.50X017
-
Catalog
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Dichtomatik 75122141 O-Ring, 17 mm ID x 22 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 17
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Gates® Power Transmission PowerGrip® 480L050 Light Timing Belt, 1/2 in W, 48 in OAL, 3/8 in Pitch, 128 Teeth, Neoprene
The trapezoidal tooth profile of PowerGrip™ Timing belts offers a maintenance-free and economical alternative to conventional chain drives and is well suited for use in positioning applications.
The 6210 Fiberglass 10 ft Step Ladder is Ideal for the homeowner or the professional. With a duty rating of 300 pounds, it features a HolsterTop with the lock-in System to secure tools from falling while keeping them right at hand. The ladder offers a full set of rear horizontals and heavy duty internal spreaders. All steps are knee braced and the foot pads are riveted to the Edge® structure. The EDGE bracing system helps protect the rail from damage. Each TRACTION-TRED® step is slip resistant and double riveted. Fiberglass rails are non-conductive for working near electricity.
50-B-21-F1-7/16 21 Tooth Sprockets For #50
21 TOOTH SPROCKETS FOR #50 CHAIN-IDC50B21F17/16 >
Tuff-Seal™ Wire Mesh Cable Grips distribute stress over a large area to prevent damage to wire, cable and flexible conduit. They are built to perform their task over an extended period of time without loosening their hold. All Remke wire mesh grips are available in a wide selection of cable ranges and eye styles where applicable and can be used in conjunction with any RSR cord connector.
Eklind® 10914 Long Key Set With Pouch, 14 Pieces, T6 to T55 Torx, L-Handle Handle, Alloy Steel, Black Oxide
Eklind® 10914 Long Key Set With Pouch, 14 Pieces, T6 to T55 Torx, L-Handle Handle, Alloy Steel, Black Oxide
