BBI 087524 Partially Threaded Cap Screw, 3/4-10, 4 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 087524 Partially Threaded Cap Screw, 3/4-10, 4 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
-
BrandBBI
-
Manufacturer Part Number087524
-
CountryUSA
-
FinishZinc CR+3
-
Tensile Strength120000 psi
-
MaterialCarbon Steel
-
Material SpecificationASTM B633
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade5
-
Hardness25 to 34 HRC
-
Head Size15/32 in H
-
Head TypeHex
-
Shank Size3/4 in
-
Diameter - Thread Size3/4-10
-
Length Under Head4 in
-
UNSPSC31161501
-
Package Description25/CS
-
Standards/ApprovalsASME B18.2.1
-
Catalog
Recently Viewed
BBI 087524 Partially Threaded Cap Screw, 3/4-10, 4 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 087524 Partially Threaded Cap Screw, 3/4-10, 4 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
Weiler® 09430 WST-8 2-Section Wheel Brush, 8 in Dia Brush, 3/4 in W Face, 0.016 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 2 in Arbor Hole
Weiler® 09430 WST-8 2-Section Wheel Brush, 8 in Dia Brush, 3/4 in W Face, 0.016 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 2 in Arbor Hole
XP™ ceramic flap discs are designed with premium XP™ ceramic cloth for long life and fast material removal. These flap discs are intended for surface prep grinding, along with grinding and blending welds. The ceramic flap disc allows you the ability to grind flat on materials with a finish of a fiber disc. These discs perform 50% faster than standard flap discs (50% faster vs XP™) and provides 2.5X longer life than the standard flap disc.
BBI 455406 Partially Threaded Cap Screw, 9/16-18, 2-1/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455406 Partially Threaded Cap Screw, 9/16-18, 2-1/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
DOUBLE OPEN FACE BALL BEARING - GULR20>
