Crosby® 1043711 G-291-7/8 X 8 Eye Bolt With Regular Nut, 7/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
Crosby® 1043711 G-291 Eye Bolt With Regular Nut, 7/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
-
BrandCrosby®
-
UPC662547437116
-
Manufacturer Part Number1043711
-
CountryUSA
-
FinishHot Dipped Galvanized
-
Thread Length4 in
-
MaterialForged Steel
-
Thread TypeUNC
-
Measurement SystemImperial
-
SeriesG-291
-
Working Load10600 lb
-
Shank Length8 in
-
Diameter - Thread Size7/8 in
-
Inside Eye Diameter1-3/4 in
-
Outside Eye Diameter3-1/2 in
-
Overall Length11-3/4 in
- Fatigue rated at 1-1/2 times the working load limit at 20000 cycles
- Hot dip galvanized after threading (UNC)
- Furnished with standard hot dip galvanized hex nuts
- Recommended for in-line pull
- Importantly, these bolts meet other critical performance requirements including fatigue life, impact properties and material traceability
-
UNSPSC31161610
-
Standards/ApprovalsASME B30.26|CE Certified
-
Catalog
Recently Viewed
Crosby® 1043711 G-291-7/8 X 8 Eye Bolt With Regular Nut, 7/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
Crosby® 1043711 G-291 Eye Bolt With Regular Nut, 7/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
MEDIUM 8-MIL NO POWDER NITRILE GLOVE-BOX OF 50 - GLV6030M>
MEDIUM 4-MIL POWDER NITRILE GLOVE--BOX OF 100 - GLV6020M >
The Fluidmaster 218 Refill Tube and Clip Replacement offers a proven solution to replace corroded, or leaky refill tubes. Featuring an easy to install design, that works with not only Fluidmaster toilet fill valves, including 400A, but will also work with most other fill valves. Eliminate purchasing a new fill valve with a simple DIY toilet repair part. Built with quality rubber and plastic materials, and including a 1 year warranty.
Crosby® 1043515 G-291-5/8 X 8 Eye Bolt With Regular Nut, 5/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
Crosby® 1043515 G-291 Eye Bolt With Regular Nut, 5/8 in, 8 in L Shank, Forged Steel, Hot Dipped Galvanized
Linn 20FS30 Rough Bore Spur Gear, 20 Diametral Pitch, 14.5 deg Pressure Angle, 3/8 in W Face, 30 Teeth, 1-1/2 in Dia Pitch, 3/8 to 3/4 in Dia Bore, Steel
Steel spur gears in 20 to 2 Diametral Pitch - 14.5 deg pressure angle stocked. Other circular, metric or D. P. sizes made-to-order in 14.5 deg, 20 deg or other pressure angles from steel, nylon, phenolic, bronze, cast iron or other materials up to 96 in Dia Internal gears and ground external profiles may be provided subject to equipment limitations.
