Crosby® 1045292 G-277-1 X 6 Eye Bolt With Shoulder Nut, 1 in, 6 in L Shank, Forged Steel, Hot Dipped Galvanized
Crosby® 1045292 G-277 Eye Bolt With Shoulder Nut, 1 in, 6 in L Shank, Forged Steel, Hot Dipped Galvanized
-
BrandCrosby®
-
UPC662547452928
-
Manufacturer Part Number1045292
-
CountryUSA
-
FinishHot Dipped Galvanized
-
Thread Length3 in
-
MaterialForged Steel
-
Thread TypeUNC
-
Measurement SystemImperial
-
SeriesG-277
-
Working Load13300 lb
-
Shank Length6 in
-
Diameter - Thread Size1 in
-
Inside Eye Diameter2 in
-
Outside Eye Diameter3-3/4 in
-
Overall Length9.97 in
- Fatigue rated at 1-1/2 times the working load limit at 20000 cycles
- Working load limits shown are for in-line pull
- Importantly, these bolts meet other critical performance requirements including fatigue life, impact properties and material traceability
- Hot dip galvanized after threading (UNC)
- Furnished with standard hot dip galvanized, heavy hex nuts
-
UNSPSC31161610
-
Standards/ApprovalsASME B30.26|CE Certified
-
Catalog
Recently Viewed
Crosby® 1045292 G-277-1 X 6 Eye Bolt With Shoulder Nut, 1 in, 6 in L Shank, Forged Steel, Hot Dipped Galvanized
Crosby® 1045292 G-277 Eye Bolt With Shoulder Nut, 1 in, 6 in L Shank, Forged Steel, Hot Dipped Galvanized
1-3/8" CAM FOLLOWER-MCGCF13/8S >
5-HP, TEFC, 3-PH, 208-230/460-V, 1200-RPM, 215-T MOTOR - USMH5P3D >
Gates® Power Transmission Super HC® PowerBand® 4/5V1250 Banded Heavy Duty V-Belt, 5V Section, 5/8 in W Top, 125 in L Outside, 35/64 in THK, Chloroprene
Combines the strength of a wrapped belt construction with the economies of a narrow section V-belt. Transmits more power in a given space and allows more compact drive design than classical section V-belts. In short, it offers you more power and considerably reduces the space needed. This significantly cuts the overall drive cost. Super HC™ V-belts also have exclusive Gates construction features for longer life on your drives.
16-MJIC X 8-MORB 90-D HYD/ADAPTERS-DAY6801168>
The forged steel jaws of this left-cutting snip are set at a 90-degree angle to the handles to allow easy gripping when cutting sheet metal in tight spaces or overhead. The operator can follow tight circular or square pattern left cuts with either a pushing or pulling motion. A serrated edge on the upper jaw and compound head-to-handle linkage provide powerful, non-slip leverage for cutting up to 24-gauge (0.61 mm) cold rolled steel or 28-gauge (0.38 mm) stainless. Handles feature non-slip, cushion inserts, torsion-spring action and a squeeze-open, side operated latch. Rust-resistant polished forged steel jaws and black oxide finished handle stampings promote long service life.
