Champion CT7-1-1/8 Hole Cutter, 1-1/8 in Dia, 1 in D Cutting, Carbide Cutting Edge
Champion CT7-1-1/8 Hole Cutter, 1-1/8 in Dia, 1 in D Cutting, Carbide Cutting Edge
-
BrandChampion
-
UPC846035054942
-
Manufacturer Part NumberCT7-1-1/8
-
CountryUSA
-
Applicable MaterialsAluminum, Copper, Cutting Steel Plate, Cast Iron, FRP, Iron, Plastics and Stainless Steel
-
SeriesCT7
-
Cutting Depth1 in
-
Shank Size3/8 in
-
Cutting Edge MaterialCarbide
-
Shank TypeStraight
-
Diameter1-1/8 in
-
Body MaterialSteel
-
Overall Length3-3/32 in
- Special tungsten carbide teeth - excellent wear and heat resistance
- 1-piece construction - stable accurate drilling
- Ejector spring ejects the slug saving time
- Safety collar stop prevents over penetration for safer, faster operation
- Cut longer and faster than hole saws and twist drills, increasing productivity on the job
- Perfect portable tool for the professional electrician, plumber, mechanic and contractor
- Better than bi-metal hole saws
- Carbide tipped hole cutter features special ultra hard tungsten carbide triple edge cutting system, pilot drill and ejector spring
- 9/16 to 3 in have 3/8 in shank
-
UNSPSC23241600
-
Specification Sheet
Recently Viewed
Champion CT7-1-1/8 Hole Cutter, 1-1/8 in Dia, 1 in D Cutting, Carbide Cutting Edge
Champion SA80-1 Car/Maintenance Reamer, 1 in Dia x 7-3/16 in OAL, 1/2 in Dia Straight Shank, Left Helical Flute
Champion SA80-1 Car/Maintenance Reamer, 1 in Dia x 7-3/16 in OAL, 1/2 in Dia Straight Shank, Left Hand Helix Flute
16-TOOTH #60-1 CHAIN SPROCKETS IDC 60-B-16-F1-1/2
16 TOOTH SPROCKETS FOR #60 CHAIN
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
M12" X 40 SOCKET HEAD CAP SCREWS-HOL76372 >
PLASTIC HANDLE WHITE NYLON FENDER WASH BRUSH - MAG73N >
