Drillco 74A124C 7400 Center Cutting Double End Imperial Stub Length Finishing End Mill, 3/8 in Dia Cutter, 1/2 in Length of Cut, 2 Flutes, 3/8 in Dia Shank, 2-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
-
BrandDrillco
-
UPC045997391229
-
Manufacturer Part Number74A124C
-
CountryUSA|Canada
-
FinishUncoated
-
MaterialSolid Carbide
-
Flute TypeSpiral
-
TypeCenter Cutting Double End Imperial Stub Length
-
Helix Angle30 deg
-
Series7400
-
Cutter Diameter3/8 in
-
Shank Diameter3/8 in
-
Number of Flutes2
-
Cutting DirectionRight Hand
-
Shank TypeRound
-
Length of Cut1/2 in
-
Overall Length2-1/2 in
- Solid carbide construction for extreme rigidity and strength
- Solid carbide can be ran at 3x the speed and feed of HSS
- Center cutting tip for plunging, pocketing and holemaking
- 2 flutes provide more efficient chip removal
- Bright finish for added lubricity
- Stub length for added rigidity
- Double ended for 2x the life
-
UNSPSC27112803
-
Package Description1/PK
-
Standards/ApprovalsPROP65: This product can expose you to chemicals including Cobalt, which is [are] known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
-
SDS
-
Catalog
Recently Viewed
Drillco 74A124C 7400 Center Cutting Double End Imperial Stub Length Finishing End Mill, 3/8 in Dia Cutter, 1/2 in Length of Cut, 2 Flutes, 3/8 in Dia Shank, 2-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
NEEDLE BEARING INNER RACES-INAPI121616>
4-1/2" 5/8" -11 SURF/COND BACK PAD-PDTMM85840042 >
3/8" DIAMETERX1-1/4" DOWEL PIN-HOL01096 >
10-GRV BANDED B-144 V-BELT-JAS10RB144 >
Browning® 1074384 Type J Q-D® Bushing, 2-15/16 in Dia Bore, 5.1484 in Dia Barrel, 7-1/4 in Dia Flange, 4.51 in OAL, Steel
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
