MORSE® 22733 1701 Bridge Reamer, 1-3/16 in Dia x 12 in L, #3 Morse Taper Shank, Left Spiral Flute
MORSE® 22733 1701 Bridge Reamer, 1-3/16 in Dia x 12 in L, #3 Morse Taper Shank, Left Hand Spiral Flute
-
BrandMORSE®
-
UPC686125227333
-
Manufacturer Part Number22733
-
CountryUSA
-
FinishBlack Steam Oxide
-
Point Size7/8 in
-
MaterialHSS
-
Flute Length7-3/8 in
-
Flute TypeLeft Spiral
-
Applicable MaterialsStructural Steel
-
Series1701
-
Cutting DirectionRight Hand
-
Shank Type#3 Morse Taper
-
Diameter1-3/16 in
-
Overall Length12 in
-
UNSPSC23241611
-
Package Description1/PK
-
Standards/ApprovalsNSF Listed
-
Catalog
Recently Viewed
MORSE® 22733 1701 Bridge Reamer, 1-3/16 in Dia x 12 in L, #3 Morse Taper Shank, Left Spiral Flute
MORSE® 22733 1701 Bridge Reamer, 1-3/16 in Dia x 12 in L, #3 Morse Taper Shank, Left Hand Spiral Flute
NACHI 7314B Angular Contact Ball Bearing, 70 mm Dia Bore, 150 mm OD, 1 Row, 35 mm W, 40 deg, 118000 N Dynamic/88500 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
12/24-V SELF ADJUST BACKUP ALARMS-NASBA2A>
BBI 401440 Partially Threaded Cap Screw, 5/8-11, 3 in L Under Head, 316 Grade, Stainless Steel
BBI 401440 Partially Threaded Cap Screw, 5/8-11, 3 in L Under Head, 316 Grade, Stainless Steel
Porter-Cable® FN16225 Finish Nail, 2-1/4 in L, 16 ga
HCI Preferred Supplier 20085 90 deg Swivel Elbow, 1/2 in Nominal, Push-In x MNPTF End Style, Forged Brass
HCI Preferred Supplier 20085 90 deg Swivel Elbow, 1/2 in Nominal, Push-In x MNPTF End Style, Forged Brass
