BBI 502201 Full Thread Tap Bolt, 1/2-13, 1-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 502201 Full Thread Tap Bolt, 1/2-13, 1-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
-
BrandBBI
-
Manufacturer Part Number502201
-
CountryUSA
-
FinishZinc CR+3
-
Tensile Strength120000 psi
-
MaterialMedium Carbon Steel
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypeFull Thread
-
Grade5
-
Hardness25 to 34 HRC
-
Head Size11/32 in H
-
Head TypeHex
-
Diameter - Thread Size1/2-13
-
Length Under Head1-1/2 in
-
UNSPSC31161620
-
Package Description50/CS
-
Standards/ApprovalsASME B18.2.1
-
Catalog
Recently Viewed
BBI 502201 Full Thread Tap Bolt, 1/2-13, 1-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 502201 Full Thread Tap Bolt, 1/2-13, 1-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
#14 X 5/8" Pan Head Combo Sheet Metal Screws
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
BBI 401440 Partially Threaded Cap Screw, 5/8-11, 3 in L Under Head, 316 Grade, Stainless Steel
BBI 401440 Partially Threaded Cap Screw, 5/8-11, 3 in L Under Head, 316 Grade, Stainless Steel
Synchronous belt drives help reduce the problems of slippage, belt stretch, lubrication and metal to metal contact. They provide superior performance because power is transmitted by positive engagement of belt teeth rather than by friction, as in conventional belt drives.
ISOSTATIC™ Oilube® 401335 Round Bore Sleeve Bearing, 1 in Dia Bore, 1-1/4 in OD, 3 in W
ISOSTATIC™ Oilube® 401335 Round Bore Sleeve Bearing, 1 in Dia Bore, 1-1/4 in OD, 3 in W
