Morse® 194615 A Plate Ground Sprocket, 28 Teeth, For Use With Model 350 Torque Limiter Model, 120.4 mm OD
Morse® 194615 A Plate Ground Sprocket, 28 Teeth, For Use With Model 350 Torque Limiter Model, 120.4 mm OD
-
BrandMorse®
-
UPC662288949275
-
Manufacturer Part Number194615
-
CountryUSA
-
TypeA Plate
-
Number of Teeth28
-
Outside Diameter120.4 mm
-
Suitable For Use WithModel 350 Torque Limiter Model
- Morse and Browning offer a complete line of Torque Overload Devices to protect machinery from overloads or jams
- Torque limiter bushing must be purchased separately
- Double-shielded bearings extend the service life of the motor
- Automatic reset thermal protector (as noted) protects against overload
- Moderate starting torque helps reduce fan stresses
-
Alternative Part Number350-AG428 SPKT PKG
-
UNSPSC31171901
-
Package DescriptionEACH
-
WarrantyLimited
-
Catalog
Recently Viewed
Morse® 194615 A Plate Ground Sprocket, 28 Teeth, For Use With Model 350 Torque Limiter Model, 120.4 mm OD
Morse® 194615 A Plate Ground Sprocket, 28 Teeth, For Use With Model 350 Torque Limiter Model, 120.4 mm OD
Browning® 1305002 Stock Shear Pin, 3/16 in Dia Neck, 1-1/8 in OD, For Use With Model SHH1 Hub, 3730 in-lb Torque, Steel
Browning® shear pin hubs are designed to shear a necked pin at a predetermined load. This protects equipment from overloads. Consisting of a hub assembly, a sprocket and shear pin, the shear pin bridges between the sprocket and hub assembly. The shear pin is available in load increments, so the closest one to your application requirements must be chosen. Resetting the shear pin hub is accomplished manually by replacing the shear pin. Best applied to applications where infrequent overloads are encountered.
12 TOOTHHHN GREEN ELECTRICAL WIRE (FT)-ALE12THHNGRNSOLID >
FHP V-BELT 48."-JAS4L480 >
32-OZ " THE WORKS" DRAIN CLEANER-JWH605409 >
JACKSON SAFETY® 14812 C10 Lightweight Bump Cap, Universal, Green, HDPE, 4-Point Pinlock Suspension, ANSI Specified
Jackson Safety* C10 bump caps can help provide on the job protection your workers. They help offer protection from minor bumps and scalp lacerations (where ANSI standards are not required). These lightweight safety hats are made of molded HDPE (high density polyethylene) and feature a 4-point suspension system with an absorbent brow pad. The pinlock sizing system can accommodate head sizes 6.5 to 8.25 and the helmets can be made compatible with a face shield for additional coverage.
