Gates® Power Transmission Polyflex® JB® 3/7M710JB Joined Band Light Duty V-Belt, 7M Section, 9/32 in W Top, 27.7 in L Outside, 7/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
-
BrandGates® Power Transmission
-
UPC72053263657
-
Manufacturer Part Number3/7M710JB
-
CountryUSA|Canada
-
Temperature Range-65 to 180 deg F
-
Thickness7/32 in
-
MaterialHigh Modulus Polyurethane
-
Top Width9/32 in
-
Reinforced MaterialPolyester
-
TypeJoined Band Light Duty
-
Minimum Pulley Diameter2.546 in
-
Section Size7M
-
Series8913
-
Number of Ribs3
-
Outside Length27.7 in
- High modulus polyurethane compound resists fatigue, wear, ozone and most environmental conditions
- Precise casting method eliminates layers and overlaps for smooth running and low vibration
- Ribbed backing provides greater lateral stability and relieves bending stress
- Joined belt construction provides high stability, preventing belts from turning over or coming off of the drive
-
Alternative Part Number89133710
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsRMA Standard
-
Catalog
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Gates® Power Transmission Polyflex® JB® 3/7M710JB Joined Band Light Duty V-Belt, 7M Section, 9/32 in W Top, 27.7 in L Outside, 7/32 in THK, High Modulus Polyurethane
Developed by Gates and produced to patented manufacturing processes, these belts provide more load-carrying capacity at higher speeds to small multiple V-belt precision drives. This results in significant cost savings and improved design freedom.
Krylon® 3106 Fluorescent Paint, 11 oz Container, Liquid Form, Green
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
IVORY SPRAY PAINT-KRY1504 >
United Abrasives-SAIT 23050 Thin High Speed Cut-Off Wheel, 3 in Dia x 0.035 in THK, 3/8 in Center Hole, A36T Grit, Aluminum Oxide Abrasive
Browning 2-3/16"-ID 4-BOLT TRB FLANGE UNITS BRW FBE-920 X 2-3/16
Browning® E920 series mounted tapered roller bearings feature durable 1-piece non-expansion housings with Type E mounting dimensions and limited misalignment. The E920 series contains setscrew locking collars for easy installation. It also contains a contact face riding seal in order to provide a good balance between contaminant entry, grease retention and friction. Depending on your application requirements, these bearings are available in a wide variety of bore sizes and housing configurations.
