Gates® Power Transmission Hi-Power® II BB43 Banded Heavy Duty Double V-Belt, BB Section, 21/32 in W Top, 46 in L Outside, 17/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
-
BrandGates® Power Transmission
-
UPC72053203424
-
Manufacturer Part NumberBB43
-
CountryUSA|Canada
-
Thickness17/32 in
-
MaterialEPDM
-
Top Width21/32 in
-
Reinforced MaterialFlex-Bonded Polyester
-
TypeBanded Heavy Duty
-
Minimum Pulley Diameter5.73 in
-
Section SizeBB
-
Series9053
-
Number of Ribs1
-
Outside Length46 in
- Flex-bonded cords are strongly bonded to the body of the belt resulting in equal load distribution and the absorption of bending stress without cord deterioration
- The Flex-Weave® cover is constructed for longer cover life, providing extended protection to the core of the belt from oil, dirt and heat
- Gates® curves provide proper cord support and full contact with the sheave groove for uniform loading, uniform wear and increased belt life
-
Alternative Part Number90530043
-
UNSPSC26111801
-
Package DescriptionEACH
-
Standards/ApprovalsARPM/RMA IP-3-2/IP-3-3
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Gates® Power Transmission Hi-Power® II BB43 Banded Heavy Duty Double V-Belt, BB Section, 21/32 in W Top, 46 in L Outside, 17/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
National Hardware® N324-665 BB2014 Large Screw Eye, 1.94 in L, 3/4 in L Thread, 0.53 in ID Eye, Steel
Drillco 73A108C 7300 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1/8 in Dia Cutter, 3/8 in Length of Cut, 4 Flutes, 1/8 in Dia Shank, 1-1/2 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
26-MM-OD STUD TYPE CAM FOLLOWERS-IKOCF101VBUUR>
Link-Belt 1-1/2"-ID 3-BOLT SRB FLANGE UNITS LNK F-EB-22424-H
Self aligning double row spherical roller bearings are designed to distribute the load over the symmetrical rollers, assuring positive tracking and smooth operation. The large roller complement provides high capacity for radial or combined radial-thrust loads. Osculation clearance at the ends of the rollers compensates for shock loads and prevents destructive edge loading. These precision bearings with double contoured retainer pockets are designed to meet a broad range of application requirements.
FUEL FILTERS
