IKO Bearings NEEDLE BEARING INNER RACES IKO IRB-1616
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. These rings are designed to provide a durable surface for shell-type needle roller bearings with non-machined raceways in-type IRB series shaft diameters range from 5/16 to 2-1/2 in.
-
BrandIKO
-
Manufacturer Part NumberIRB1616
-
CountryUSA
-
MaterialHigh Carbon Steel
-
Inside Diameter1 in
-
Bore TypeTapered
- Without oil hole
-
UNSPSC31171547
-
Catalog
Recently Viewed
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. These rings are designed to provide a durable surface for shell-type needle roller bearings with non-machined raceways in-type IRB series shaft diameters range from 5/16 to 2-1/2 in.
10-GROOVE BANDED BX-53 V-BELT - PIXBX53/10>
SIDE MOUNT STEEL TAKE-UP FRAMES-FAFNLTU3 >
MORSE® 44629 1980 Regular Length Single End Drill Mill, 3/4 in Dia, 90 deg Point, 2 Flutes, 1-11/16 in L Flute, 1-11/16 in L of Cut, 3-15/16 in OAL, Bright
Milwaukee® M18™ FUEL™ SAWZALL® 2721-20 Adjustable Shoe Adjustable Shoe Anti-Vibration Cordless Reciprocating Saw With One-Key™, 1-1/8 in L Stroke, 0 to 3000 spm, Straight Stroke, 18 VDC, 17-3/4 in OAL
MORSE® 43682 1898 Center Cutting Regular Length Single End End Mill, 1-1/4 in Dia Cutter, 1-5/8 in Length of Cut, 2 Flutes, 1 in Dia Shank, 4-1/8 in OAL, Bright
