FED/Bronze 5/8" X 7/8" X 1" BRONZE BUSHINGS FEB SS-20-28-16
ISOSTATIC™ Oilube® 401200 Round Bore Sleeve Bearing, 5/8 in Dia Bore, 7/8 in OD, 1 in W
-
BrandISOSTATIC™
-
UPC846802044954
-
Manufacturer Part Number401200
-
CountryUSA
-
Temperature Rating10 to 175 deg F
-
Maximum PV Rating50000 psi/sq-ft/min
-
Maximum Pressure2000 psi
-
Maximum Velocity1200 sfpm
-
TypeRound Bore
-
Width1 in
-
Bearing MaterialSAE 841 Powdered Metal/Oil Impregnated Bronze
-
Outside Diameter7/8 in
-
Bore Diameter5/8 in
- Standard stock products
- SAE 841 copper (87 to 90%), tin (8 to 9%), carbon and other elements
- Powdered metal bronze providing interconnected reservoirs for oil
- Vacuum impregnated with SAE 30 oil during the manufacturing process
- Self-lubricating, when in motion oil rises to the surface for lubrication and restores itself when at rest
- Ideal for heavy loads at moderate speeds or light loads at high speeds
-
Alternative Part NumberSS-2028-16
-
UNSPSC31171509
-
Package Description1/PK
-
Standards/ApprovalsROHS|REACH|DFARS Compliant|PROP65: This product can expose you to chemicals including polybrominated biphenyls which is known to the state of California to cause cancer and cadmium which is known to the state of California to cause birth defects or other reproductive harm. For more information go to www.P65WARNINGS.ca.gov
-
Specification Sheet
-
Catalog
Recently Viewed
ISOSTATIC™ Oilube® 401200 Round Bore Sleeve Bearing, 5/8 in Dia Bore, 7/8 in OD, 1 in W
11 TOOTH #60 CHAIN IDLER SPROCKETS-IDC60NB11H >
Milwaukee® 49-56-2003 Hole Saw, 2 in Dia, 1-5/8 in D Cutting, Tungsten Carbide Cutting Edge
Milwaukee® carbide tipped hole saws provide long life and faster cutting in cement board, ceramic tiles, fiberglass and wood products such as fiberboard, flake board and plywood. Use a carbide tipped pilot bit (49-56-8005) when cutting ceramic tile, brick and other abrasive materials.
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
ISOSTATIC™ Oilube® 401146 Round Bore Sleeve Bearing, 1/2 in Dia Bore, 3/4 in OD, 1-1/4 in W
BBI 455322 Partially Threaded Cap Screw, 1/2-13, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455322 Partially Threaded Cap Screw, 1/2-13, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
