FYH® SA206 20FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-1/4 in Dia Bore, 1.18 in W, 19.5 kN Dynamic/11.3 kN Static Load
FYH® SA206 20FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-1/4 in Dia Bore, 1.18 in W, 19.5 kN Dynamic/11.3 kN Static Load
-
BrandFYH®
-
Manufacturer Part NumberSA206 20FP9
-
CountryUSA
-
Load Capacity19.5 kN Dynamic/11.3 kN Static
-
TypeNarrow
-
Width1.18 in
-
SeriesSA Series
-
Bore Diameter1-1/4 in
Recently Viewed
FYH® SA206 20FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-1/4 in Dia Bore, 1.18 in W, 19.5 kN Dynamic/11.3 kN Static Load
FYH® SA206 20FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-1/4 in Dia Bore, 1.18 in W, 19.5 kN Dynamic/11.3 kN Static Load
Dodge® 042106 515 Both Ends Open Split Type SAF-XT Pillow Block Housing, Two-Bolt Base Mount, 3-1/4 in Base to Bore Centerline, 11-1/4 in OAL 6.44 in OAH
The SAF-XT pillow block housing is designed for typical SAF dimensional interchangeability, complete with such desirable features as 2-bolt caps, cap removal pry slots, elongated bolt holes, and dimpled feet for doweling. In addition to these features the SAF-XT housing also incorporates a better grease purging/sealing system for extra protection of the bearing in a hostile environment.
HAIR PIN HITCH CLIPS-HIG00017>
#4 X 1/4" Pan Head Combo Sheet Metal Screws
DAP® Fast 'N Final® 12142 Lightweight Spackle, 1 qt Tub, White to Off-White
DAP® Fast 'N Final® lightweight Spackling lets you patch and prime in one easy step, saving time and money. It dries fast with no need to sand or prime, letting you paint in minutes for a virtually invisible repair. Ideal for repairing holes, cracks and dents in drywall, plaster, wood and stucco. Interior/exterior use.
Koyo TRA-1018 Double Direction Thrust Washer, 15.88 mm ID x 28.58 mm OD, 0.81 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
