Oatey® Retro Master Flash® 14049 Roof Flashing, EPDM, 1/4 to 4 in Pipe, 8 in W x 8 in L Base
Oatey® Retro Master Flash® Roof Flashings are engineered for profiled roofing material and designed for installations where standard flashing can't be used because of continuous pipe or obstructions. Oatey products have earned the trust of plumbing professionals for over 100 years.
-
BrandOatey®
-
UPC038753140490
-
Manufacturer Part Number14049
-
CountryUSA|Canada
-
Pipe Size1/4 to 4 in
-
MaterialEPDM
-
Base Length8 in
-
Base Width8 in
- 8 in x 8 in soft aluminum base for profiled metal roofs
- Easily customized to accommodate use on multiple pipe sizes
- Most commonly used with an existing roof penetration, when installing a flashing over the pipe is not an option and requires a hard-to-reach or wrap-around installation
- Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
- Slide over pipe, use silicone sealant between base and surface, then secure with sheet metal screws
- Flexible base conforms to most flat or contoured roof surfaces including clay tile and metal roofs, sliding over vent pipe with pitch from 0-45
- Non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
- Rated to withstand 212F continuous heat and approved for Type B installations, intermittent temperature resistance to 275F
- Do not use petroleum based products on Retro Master Roof Flashings
-
UNSPSC40101500
-
Package DescriptionBOX
-
Standards/ApprovalsIAPMO Listed|NES 623|UPC Listed
-
Catalog
-
Specification Sheet
Recently Viewed
Oatey® Retro Master Flash® 14049 Roof Flashing, EPDM, 1/4 to 4 in Pipe, 8 in W x 8 in L Base
Oatey® Retro Master Flash® Roof Flashings are engineered for profiled roofing material and designed for installations where standard flashing can't be used because of continuous pipe or obstructions. Oatey products have earned the trust of plumbing professionals for over 100 years.
5-TON L-100 10'-LIFT HAND CHAIN HOIST - JET101550>
3/4" SCH-80 CPVC SOCKET CAPS-NIB1847007 >
Reed 03320 1-Wheel Pipe Cutter, 1/8 to 2 in, Tool Steel Cutting Edge, Short Handle
REED offers a variety of pipe cutters, both with and without guides. Standard pipe cutters without guides feature strong malleable iron frames. These pipe cutters work on steel, stainless steel, galvanized steel or cast iron pipe, depending on the installed cutter wheels. (Models ship with cutter wheels for steel.) The wide rollers help create square cuts. REED's thin profile, sharp cutter wheels allow shorter handles for work in smaller spaces. These pipe cutters leave no burr, which is great for threading jobs. The 2-3 pipe cutter with three wheels (and no rollers) means more cutting surface and less handle swing.
60203 Buffing Wheel, Cotton, 1" X 1/8" Shaft. Great For Polishing All Metals.
BUFFING WHEEL, COTTON, 1" X 1/8" SHAFT. GREAT FOR POLISHING ALL METALS.-FOR60203 >
1-TON HYDRAULIC FLOOR STYLE TRANSMISSION JACK - OMGHW93718>
