HCI Preferred Supplier 940134 Gate Valve, 1 in Nominal, 11.5 TPI FNPT End Style, C37700 Forged Brass Body
HCI Preferred Supplier 940134 Gate Valve, 1 in Nominal, 11.5 TPI FNPT End Style, C37700 Forged Brass Body
-
BrandGeneric
-
Manufacturer Part Number940134
-
CountryUSA
-
Port TypeFull
-
Pressure Rating200 psi WOG/125 psi WSP
-
Top to Inlet Center3.661 in
-
MediaCold Water, Oil, Gas and Saturated Steam
-
Trim MaterialBrass/PTFE
-
Hand Wheel Diameter2.283 in
-
Nominal Size1 in
-
Inlet to Outlet Length1.984 in
-
Softgoods MaterialNBR Rubber Seat
-
Domestic/ImportImport
-
Body MaterialC37700 Forged Brass
-
End Style11.5 TPI FNPT
- Full-port design for a better water flow
- Cast iron handle
- Good for diesel fuel
- Solid wedge
- Screw-In bonnet
- Non-Rising stem
-
UNSPSC40141613
-
Package Description5/BX
-
Standards/ApprovalsANSI B1.20.1
-
Catalog
Recently Viewed
HCI Preferred Supplier 940134 Gate Valve, 1 in Nominal, 11.5 TPI FNPT End Style, C37700 Forged Brass Body
HCI Preferred Supplier 940134 Gate Valve, 1 in Nominal, 11.5 TPI FNPT End Style, C37700 Forged Brass Body
48" X 48" FRONTLINE RED DRY PADS-AAF631227656>
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
Diversitech 590-708 Variable Motor Start Capacitor, 590 to 708 uF, 110/125 V AC, Round
Diversitech 590-708 Variable Motor Start Capacitor, 590 to 708 uF, 110/125 VAC, Round
Browning® shear pin hubs are designed to prevent damage to machinery due to sudden overload or jamming by shearing the necked pin at a predetermined load. The inner part of the hub is keyed to the shaft and remains stationary while the outer part, to which the sprocket is bolted, rotates freely after pin breakage, allowing the drive to idle. Shear pin hubs are ideal for heavily lubricated areas where a cost effective solutions is needed.
2-1/2" -FEMALE PIPE THREAD STEEL GALVANIZED COUPLING-FIT21/2GSC >
