GENERAL® 444 Depth/Angle Gage, Stainless Steel Rule/Hardened Steel Base
GENERAL® 444 Depth/Angle Gage, Stainless Steel Rule/Hardened Steel Base
-
BrandGENERAL®
-
UPC038728315861
-
Manufacturer Part Number444
-
CountryUSA
-
MaterialStainless Steel Rule/Hardened Steel Base
-
Base Length2-1/2 in
-
Dimensions6 in L x 1/4 in W Blade
- Depth/angle gage precisely measures the depth of small holes and slots
- It also works as a protractor to facilitate setting an angle to 30 deg, 45 deg or 60 deg on either side
- Etched stainless steel rule and hardened steel base
- Spring tension nut simplifies operation by securing graduated stainless steel rule in milled slot at 90 deg angle to base
-
UNSPSC41112401
Recently Viewed
GENERAL® 444 Depth/Angle Gage, Stainless Steel Rule/Hardened Steel Base
16-D COMMON NAILS >(BY POUND)-SEQ10199701LB >
The ProCart is a versatile, time-saving plastic utility cart engineered to adapt to all the ways – and all the places – you work. Side gates on both the upper and lower shelves flip down to convert this cart from a box-top to a flat-top. Built for years of rugged use, the ProCart is made of high-density polyethylene structural foam. The panels are dent-resistant, rust-proof and never need painting. Even under its 400-lb. maximum payload, the ProCart easily maneuvers around tight corners and through narrow aisles. Each shelf can hold 200 lbs. Use the optional rail kits to hang plastic storage bins or parts cabinets under the top shelf. Assembly is required.
