Gorilla® 106425 Tape, 25 yd L 2-7/8 in W, 17 mil THK, Rubber Adhesive, Polyethylene Coated Cloth Backing, Black
-
BrandGorilla®
-
Manufacturer Part Number106425
-
CountryUSA
-
Tensile Strength50 lb/in
-
Thickness17 mil
-
Maximum Operating Temperature150 deg F
-
ColorBlack
-
Minimum Operating Temperature30 deg F
-
Adhesive MaterialRubber
-
Width2-7/8 in
-
Backing MaterialPolyethylene Coated Cloth
-
Specifications MetASTM/ASTM D3330/ASTM D3759
-
Length25 yd
Recently Viewed
Reelcraft® 3-HR1005 Adjustable Hose Bumper Stop, For Use With D9000, E9000 and SD Series Hose Reels, 3/4 in ID Hose, Rubber, Black, Import
Heritage™ BP-228 Imperial Bridge Pin, 0.093 in Dia x 2 in L, Fits Shaft 1/4 to 1/2 in, MB Spring Wire, Zinc Clear
Heritage™ BP-228 Imperial Bridge Pin, 0.093 in Dia x 2 in L, Fits Shaft 1/4 to 1/2 in, MB Spring Wire, Zinc Clear
Steel shim is made from a full hard, cold rolled, low carbon 1008-1010 steel. Precision Brand® is the only manufacturer to offer Branded® shim. It has everything the user needs to know clearly marked right on the shim: material type, material thickness and lot # for full traceability. Used in applications where hardness, flatness and accuracy are required. Material can be punched or sheared with minimum burring and distortion. Precision Brand® shim stock is widely used in the following applications: tool and die set up, alignment, new machine assembly, machine repair and maintenance; mounting of motors, pumps and other machines, short run and prototype work, along with a variety of other industrial uses. It is especially useful for pilot production runs where material accuracy and economy are important. All Precision Brand® shim products are manufactured under rigorous quality control standards to assure high accuracy and tight tolerances.
12-OZ DOT-5 SILICONE BRAKE FLUID-RADM4011 >
Alemite® 1724-B 45 deg Thread Forming Fitting, 1/8 in Taper Thread, 0.83 in OAL, Steel, Trivalent Zinc Plated
Alemite thread forming fittings have special tapered drive threads which reshape the material in an untapped hole to provide a leak proof seal. They are most effectively installed by spinning into the untapped hole, but may be driven straight into the untapped hole. Thread forming fittings can be replaced by any standard threaded fitting or by another thread forming fitting.

